answersLogoWhite

0

What else can I help you with?

Related Questions

Is it possible to clean the oxygen sensors of a Ford Ranger XLT 1994 or should they be replaced?

As far as I know they can not be cleaned. Must be replaced.


What could cause a 1999 Toyota Camry check engine light to come on after replacing all the sensors and driving it for about forty miles?

what sensors have you replaced?? i am assuming the oxygen sensors. i need a code number to tell you what is wrong. if its a p0420 its probabily the catalytic converter. mabye a p0141-mass air flow needs to be cleaned


How often should o2 sensors be replaced?

They are replaced when they go bad.


1996 Aurora O2 Sensors code P0151 and P0138 can they be reset?

They can be cleared, but will return if not repaired.


How many oxygen sensors are there on a 1999 Dodge Ram van 1500 Also can they just be cleaned or is it best to replace them?

Two sensors, and replace them.


91 Chevy 4.3 running rich WHEN WARM UP?

If the oxygen sensors for the 1991 Chevy 4.3 is running rich when it is warmed up it is best to have the sensors replaced. Once the sensors are replaced this should resolve the issue.


What if 2003 Yukon keeps getting PO171 and PO174 codes Unlikely both or all 4 oxy sensors are bad?

Have you had your 4 oxygen sensors replaced? It turns out when they replaced my oxygen sensors, they were after market parts so the service engine light did not come and gave codes even though they were replaced.


Why do the ABS and FWS lights come on when brakes have been replaced and sensors cleaned on a Honda prelude 1996?

Have the ABS computer checked. I have a 94 prelude and had the same thing happen. Have the ABS computer checked. I have a 94 prelude and had the same thing happen.


Can you clean the oxygen sensors on a Chevy blazer?

No, they will need replaced if defective.


Can the wheel speed sensors be cleaned on a 2004 Yukon?

Yes, the wheel speed sensors on a 2004 Yukon can be cleaned, but it requires careful handling. You can remove the sensors from their housings and clean them using a soft brush and an appropriate cleaner, such as brake cleaner, to remove dirt and debris. However, if the sensors are damaged or worn, replacement may be necessary for optimal performance. Always refer to the vehicle’s service manual for specific instructions.


You have replaced the O2 sensors in your 1998 Mercury Mystique how do you reset the check engine light w no diagnostic scanner?

I have a 98 mystique, and when the check engine light comes on, I simply disconnect the positive battery terminal for a couple of minutes. When I replace it, the check engine light is cleared. It resets the computer.


Should a knock sensor be replaced when an oxygen sensor is?

NO. there 2 different things / sensors.