its behind the timing cover and reads a plate between two crankshaft sprockets
It is behind the crank shaft pulley in front of the motor!
Inside the timing case with the timing belt and balance shaft belt.
Where Is The Cam Sensor On A 2003 Hyundai Sonata 4 Cylinder
The crankshaft sensor needs replacing
In back of the timing cover at the bottom.
Under the timing belt cover!
Possibly Crankshaft Position sensor
On a 2000 Hyundai Sonata V6, the crankshaft position sensor is typically located near the bottom of the engine, on the engine block, close to the crankshaft pulley. It's usually mounted on the transmission bell housing or the engine block itself, making it accessible from underneath the vehicle. To locate it precisely, you may need to remove any obstructions like the engine cover or other components in the vicinity.
To change the crankshaft position sensor on a 2003 Hyundai Sonata 2.0 DOHC 16 valve, first disconnect the negative battery terminal to ensure safety. Locate the sensor, which is typically found near the crankshaft pulley or on the engine block, and disconnect the electrical connector. Remove the mounting bolt(s) securing the sensor, then pull it out. Install the new sensor by reversing the steps, ensuring the connector is securely attached before reconnecting the battery.
It is located inside the timing cover on the right side of the crankgear
You can check the Hyundai site... www.hmaservice.com... Sign up and there is a wealth of information on it. I just replaced my cam shaft position sensor on my 1999 Hyundai Sonata 4 cyl 2.4. It was a bolt and a clip. 2 minutes and done.. SONATA(EF) > 1999 > Engine > Engine ControlComponent Location Index > Camshaft Position Sensor (V6) > Camshaft Position Sensor (V6) >
where is the coolant temp sensor located on a 2006 hyundai sonata