that it would be like the craters on the moon and that it is very hard.
From Jupiter's surface, its moons would appear as bright points of light in the sky, similar to our view of Jupiter's moons from Earth. They would range in size and brightness depending on their distance from Jupiter and their individual characteristics. The sight would be quite spectacular, with some moons appearing larger than others and potentially casting shadows on Jupiter's surface.
The two moons of Mars, Phobos and Deimos, are not considered capable of supporting life. They are both small and irregularly shaped with low gravity, lack of atmosphere, and harsh surface conditions. Life as we know it would not be sustainable on these moons.
The moon Io would look the brightest from the surface of Jupiter because It is the nearest.
The moon's gravity is essentially identical to 100% of the moon's gravity, and results in gravitational forces on its surface that average about 16% of the corresponding forces on the Earth's surface.
Ganymede would appear to be the brightest moon from the surface of Jupiter. This is because Ganymede is the largest moon in the solar system and it has a high albedo, meaning it reflects a lot of sunlight. Its larger size and reflective surface would make it appear brighter than the other moons when viewed from Jupiter.
that it would be like the craters on the moon and that it is very hard.
You would not be able to see the moons from the surface; Jupiter's atmosphere is too thick.
From Jupiter's surface, its moons would appear as bright points of light in the sky, similar to our view of Jupiter's moons from Earth. They would range in size and brightness depending on their distance from Jupiter and their individual characteristics. The sight would be quite spectacular, with some moons appearing larger than others and potentially casting shadows on Jupiter's surface.
you would see all the planets around it and see the moons ground
70
To separate marbles from steel magnetic paperclips using a magnet, first spread the mixture of marbles and paperclips on a flat surface. Then, hold a strong magnet above the mixture; the paperclips will be attracted to the magnet while the marbles will remain unaffected. Carefully lift the magnet, and the paperclips will cling to it, allowing you to easily remove them from the marbles. Finally, release the paperclips from the magnet into a separate container.
The density of 10 marbles would depend on the material the marbles are made of. Generally, marbles have a density ranging from 2.5 to 2.75 grams per cubic centimeter. So, the total density of 10 marbles would be the density of one marble multiplied by 10.
33
If you had a bag of marbles, and there were two colours - red and green - and the ratio of the coloured marbles is two times the amount of green marbles to red marbles, you would have a ratio of 2:1
135 degrees.
You would be more likely to pull out a white marble as there are no red marbles in the bag.
There is no possible solution since "you" would have to have a negative number at the start.