auxillary buds
the blade of Olympus was the blade that ended the great war between the gods and the titans. Zeus was the only one who could use it because he created it himself.
Its a short staff with hidden blade.
blade uppercut blast
A helicopter blade works the same way as a wing on a fixed wing aircraft. The air flowing faster over the top of the airfoil generates lift. When a helicopter flies at a high altitude the air gets thinner. Because the air is thinner, more pitch on the blades is needed to keep the helicopter in the air. When too much pitch is on the blades the blades stall, air moves past the bottom of the blade and creates a vortex behind the top of the blade. All lift is lost and you lose altitude.
No; a lightsaber blade is made of superheated plasma focused through crystals, which lights up - and light does not cast a shadow.
The best "angle of attack" for a propeller depends on many factors, the main ones being: the speed of airflow over the blade; the distance along the blade from the centre of revolution; the physical dimensions of the blade; the density of the air which it is trying to pull, or to push, to produce the force called "thrust" which drives the blade, and the aircraft attached to it, through the air. That is why the blade does not have a simple flat surface, but one which has many angles of attack along the blade due to the complicated shape of the blade.
A compound mitre saw can cut angles in both directions and ALSO tilt the blade to cut compound angles, This is important in cutting things like crown moulding.
After his first real assignment, Altair is given the short blade.
Empoleon cannot learn the move Aqua Blade. This is primarily due to there being no move called Aqua Blade currently in Pokemon.
You may be thinking of an adze, which is a bit like a narrow ax with the blade at right angles to the handle.
A clip-point blade is like a normal blade with the back "clipped" or concavely formed to make the tip thinner and sharper.
Aside from being sharp, the blade shape of a katana supports a good cut. The profile of the blade is that it is convex, and this moves material being cut out and away from the edge of the instrument. Picture the knife as a wedge, but one where the sides are not flat. Rather, they sides are "rounded out" instead of being flat or concave. This helps explain why the blade of the katana is so good at cutting.
A compound mitre saw can cut angles in both directions and ALSO tilt the blade to cut compound angles, This is important in cutting things like crown moulding.
u eat a banana
Adz: A woodworking tool; A tool similar to an ax, with an arched blade set at right angles to the handle.
First, check to make sure the blade is not missing teeth or worn out. If so, replace it. Second, if the blade is still good but not cutting it means it is glazed over. Run the blade through an abrasive material (i.e. asphalt, masonry block, sandstone or dressing stick); this will expose the diamonds underneath. If the blade glazes over again during use, the bond of the blade is too hard for the material being cut. Simply dress the blade again by passing the blade through the abrasive material to expose more diamonds.
Technically, it is. Each blade is a lever, with the axle being the fulcrum of each lever.