answersLogoWhite

0

You have to buy a box that converts the signal from the DVD player into an RF signal. These can be found in the electronics department of most stores, or at Radio Shack.

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

Can you hook up cable to projectors?

no it is impossible to hook up cable to the projector, the only way is not hook a asr cable to the DVD out box and the take rst cable from the out cable hook into the in port on the projector in conclustion you need a DVD player also


How do you hook up a Stereo system with a Dish satellite to an old tv with only one AC input?

You can hook up a stereo system with a Dish satellite to an old TV with only one AC input by using the three plug RCA cable for the sound system. Then, use the AC input for the satellite itself.


What cable do I need to hook a VCR to a HDTV?

You will have to use RCA jacks for your VCR.In general you'll want to hook it up to an auxillary channel.The reason is that your VCR is only going to give you standard definition and you'll want to hook your HD TV up directly to an HD Sources.


How do you hook your Xbox 360 up to your computer since the computer is hooked up to the tv and the sound system?

The only way to hook it up is to have a video card that has a coax input port. You will also have to have a converter to connect the 360 Cable and the coax cable too.


How do you hook up a sony Blu-ray player to a TV through a DISH receiver?

In most cases you are unable to hookup a Blu-Ray or DVD player through a DISH receiver since they only have outputs, and no inputs. If your Blu-Ray player does have an input, all you would have to do is run a cable from the receiver to the input on the Blu-Ray device, then from the device in to your TV. Make sure it's on the correct input and you're good to go.


If your LG TV only has an optical audio output and the DVD player only has an optical output can you hook it up like that and will it work?

No.... It must be output to input...


Can a 2003 Chevy trailblazer ext CD player play mp3?

Unless you can get to the aux input to plug in a cable for an mp3 player you are stuck with CD audio only. www.trailvoy.com


Can a BluRay Disc Player hook up to any tv set up likestar choice and any size of tv?

Actually, Blu-Rays can only hook up to HDTVs by using an HDMI cable


How do you use a HDMI cable with the vbox2?

It does not have an HDMI input and only component cable inputs on the Vbox2 advanced


Where do you hook up remote wire when using stock CD player?

the remote wire only needs a power source for the amp to turn on, so if u have a looped cable running from the remote input on the amp to the front of the car with a switch and then back to the power cable on the amp u can control when the amp is on just by turning the switch on or off. otherwise u will have to figure out which cable on the back of the stereo is switched power, or which cable only supplies power when the car is running. and that would require a wiring diagram.


Cable spliter for 3 TVs it worked fine until you hooked up a digital cable box now the other two rooms can must turn the tv to channel 3 and can only see the channel the box in turned to?

Sounds like you hooked the 3-way splitter to the RF out coax jack on the cable box, which only puts out rf on channel 3 and only what the box is tuned to in regards to programming. Hook up the line from outside to the input of the splitter, each output of the splitter to each cable box/tv input.


Can I buy a different brand of cable than I have TV?

No. You do not have to buy a Samsung brand cable to hook up to the Blu Ray player. All cables seem to be the same and brand name cables only cost you more.