Can you synchronize a Sony sound bar to your dish network remote control?

Answer 1

To get the specific code to program your DISH remote to the Sony sound bar, you need to call Sony to obtain that code. I have provide instructions on how to perform a power scan to find the correct code for your sound bar.

Address To Other Equipment Using Power Scan

• Remote: All Remotes (except Basic)
  1. With the desired equipment on, press and hold the correct Mode button until all mode button back lights illuminate, then release.
  2. Press and release the Power button. AUX Mode: Before pressing and releasing the Power button
     • Press 0 for a TV
     • Press 1 for a VCR/DVD
     • Press 2 for any other device
     Then Press STAR (*)
  3. Press the Up button once a second while pointing the remote at the desired equipment. Note: If the code for the equipment comes up, the equipment will power off.
  4. Press the POUND (#) button. Note: If the code entered is valid for the remote, the mode light flashes three times.

Answer 2

Here are the instructions for programming your DISH remote:

Address Remote to TV/Other Devices

1. While at the device location (TV, etc), point the remote at the device. Press and hold the device button on the remote (TV, Aux, etc). - All four mode buttons should light up
2. Enter the three-digit remote control code - The mode button (TV, Aux, etc.)you selected should light up

If you are programming a code into AUX Mode, you must do the following before entering the device code:

Press 0 for a TV (if TV code is 500, enter 0500)

Press 1 for a VCR/DVD (if DVD code is 617, enter 1617)

Press 2 for any other device (if device code is 639, enter 2639)

1. Press the Pound (#) button - The mode button you are programming should flash three times
2. Press the large, red POWER button - The device should turn off

Answer 3

Probably not as you need to have anynet+ and your dish probably does not have this function