0
What else can I help you with?
Does iPhone 4 with bumper case fit in skullcandy pipe?
Is it an earbud, because if it is than yes. It should fit regardless, but most likely if it is an earbud.
What is the volume of a 30 pipe?
It depends on what you mean by a 30 pipe. Is 30 the cross sectional area - in which case, what is the length of the pipe? Is 30 the length - in which case, what is the cross-sectional area?
Would you need to cut the bumper on a vauxhall corsa c for a twin pipe v6?
I doubt that you would manage to fit a V6 engine in a Corsa without cutting more than the rear bumper.
How do you change the Jounce Bumper on a 1999 Dodge Grand Caravan?
Large pipe wrech...unscrew and screw new one on!
What is the formula for surface area of pipe?
2*pi*r*L where r is (outer) radius of the pipe (in case of the outer surface) nd L is the length of the pipe.
What should I do in case of a burst pipe emergency?
In case of a burst pipe emergency, turn off the water supply to prevent further damage, drain the faucets to relieve pressure, and call a plumber for repairs.
Should the muffler tailpipe extend beyond the car?
Yes, the tail pipe should extend 2" to prevent carbon build up on the vehicles rear fender and bumper.
What is the skinny line or pipe that runs on the underside of your 2003 Dodge Intrepid 2 point 7 liter engine right behind the front bumper?
Power steering cooler.
Stove pipe shooting terms?
If you're asking what the term stove pipe means, it's when the empty case of a fired cartridge is protruding from the ejection port.
What are the merits and demerits of replacing an eccentric pipe reducer with a concentric one?
Very depend on the application, concentric pipe had lower pressure drop and better flow distribution. However, in many case, eccentric pipe reducer is installed on propose to allow liquid drainage from reducing in horizontal pipe.
How do you install a trailer hitch and ball?
This will depend on the car and the hitch kit. The Hitch I put on my Fiero to pull the rase tire trailer to events was a bolt on in two hours affair. The one for my KIA is going to be a pain, the rear bumper cover is removed, the bolts to hold the metal bumper to the car are removed, the tail pipe removed. The hitch is bolted up and holes drilled for extra bolts, all the bolts are loosened off and the hitch allowed to hang, the bumper cover re-installed, the hitch bolts tightened and the new tail pipe hanger installed. Book says 3.5 hours, at home in the garage all day.
How do you pipe output?
pipe it where? to a textfile? in that case its simple, use the ">", lets say your program you want to pipe output from is called "myfile.exe" then in a cmd windows, you just type: myfile.exe > sometextfile.txt and it will run and output its spew to that file instead of the console... or lets say you want to pipe a directory listing, then its dir > mydrive.txt
