I will try to make this as simple as possible starting with the tools you will need.
Phillips Head screw driver or cordless drill
Pointy nose plyers and wire stripper
Soldering iron and solder
Something to test your wiring to see which one has power
Heat shielding or electrical tape
I think that's it!
The red wire is normally power and the black ground, the speakers are something you can work out by sound or looking at the speakers they are connected to.
The kenwood will come with a harness that plugs in the back of the steroe, the Ford harness will not fit the kenwood so you will have to cut the ford harness (not to short from the plug) and then solder the kenwood harness on to it.
Hope that helps.
each car has its own code,, contact ford.
don't
I just got one for a stereo I bought off a guy and it is a kenwood, so I went to kenwooc.com and downloaded it for free. Maybe it will work for your stereo. Good Luck.
Buy a kit to replace the double din hole.About$20 at Super cheap.
Try the Install Doctors at www.installdr.com. Good site for stereo wiring diagrams. Hope this helps.Good luck
Try the,Install Doctors at www.installdr.com. Good site for finding stereo wiring diagrams. Hope this helps. Good luck
If you're asking if the BA Falcon is a Ford, yes.
Ford XY Falcon was created in 1970.
Ford XF Falcon was created in 1984.
Ford EF Falcon was created in 1994.
Ford BF Falcon was created in 2005.
Ford EL Falcon was created in 1996.