Press the reset button on your car CD player. For example my kenwood would have the reset button located on the facia front.
Kenwood car stereos have protect mode and sometimes it gets turned on. If someone wants to turn it off, they need to remove the stereo and unplug different wires to determine which one is causing the protect mode to be on.
I blew an engine fuse on my Miata and my Kenwood KDC-X859 went into the theft security mode when I reconnected it to power. After a lot of research and trial-n-error I was able to reset the code. I put the entire process and all of the useful links on my blog: http://techbybucky.blogspot.com -Bucky
Your Kenwood radio may go into protect mode when you turn right due to a loose or damaged wiring connection, particularly if the movement affects the wiring harness. This can cause a short circuit or a drop in power supply, triggering the radio's protection feature to prevent damage. Additionally, if the speakers are improperly connected or if there's a short in the speaker wires, it could lead to similar issues. Inspecting the wiring and connections can help identify and resolve the problem.
reset the average mpg reading
TIME mode: Press and Hold "Reset" CHRONO mode: Press "ST/SP" and then press and hold "Reset" TIMER mode: [Sorry, I don't know] ALARM mode: [Sorry, I don't know]
on the side of it there is a reset under the lock mode button
jaguar sovereign engine failsafe mode reset
To get your Kenwood KDC-MP245 CD player out of protection mode, first, ensure that the wiring is secure and not shorted. Disconnect the unit from power for about 10 minutes, then reconnect it and check if the protection mode persists. If it does, inspect the speaker connections and ensure they are not shorted or damaged. If the issue continues, it may require professional repair or replacement.
Press mode Press mode again Then press mode and reset simultanously Start/stop changes digit Reset changes between the hour, minute, day, and date
Reset your password using the verification method below:
To set the date, the receiver must be in the "Standby" mode. Sources -> Standby Then the date menu item will appear in the setup menu.