To set the alarm on your Sioscan model 30724, first, locate the alarm setting button on the device. Press the button to access the alarm menu, then use the navigation buttons to set your desired alarm time. Once set, confirm the settings by pressing the appropriate button, and ensure the alarm indicator is activated. Refer to the user manual for specific instructions tailored to your model.
To set the alarm on a Sharp model SPC315, first press the "Alarm" button to enter alarm setting mode. Use the "Hour" and "Minute" buttons to adjust the time for the alarm. Once set, press the "Alarm" button again to confirm the settings. Ensure the alarm is activated by checking that the alarm indicator is displayed on the screen.
http://skyscan.info/content/ lists manuals for Skyscan (SIOSCAN is the temp transmitter). 38229 not listed but other units may be similar.
To set the alarm on the SkyScan Atomic Clock model 38229-1, first, press the "ALARM" button to enter the alarm setting mode. Use the "HOUR" and "MIN" buttons to adjust the desired alarm time. Once set, press the "ALARM" button again to confirm and exit the setting mode. Ensure the alarm is activated by checking that the alarm icon is displayed on the screen.
To turn off the alarm on the Skyscan atomic clock model 38229-1, press the "ALARM" button until you see the alarm time flash on the display. Then, press the "SET" button to deactivate the alarm. You should see the alarm icon disappear, indicating that the alarm is off. Be sure to check the owner's manual for specific instructions related to your model.
To set the alarm on the Remington handheld personal alarm system, first, locate the power switch and turn the device on. Then, press the designated alarm button, usually marked clearly, to activate the alarm feature. Some models may require you to hold the button for a few seconds or set a specific mode, so refer to the user manual for specific instructions based on your model. Ensure the alarm is functioning by testing it before needing to rely on it in an emergency.
To set the alarm on a WR 50M watch, usually you can press the "Mode" button until you reach the alarm mode. From there, you can press the "Set" button to configure the desired alarm time. Once you have set the alarm time, remember to save the setting and activate the alarm function.
You can set the alarm volume on a sliding scale of one to ten for the Elgin Travel Alarm Clock.
how do you set the alarm on the Timex T434s nature sounds triple alarm clock radio
To unset the alarm on a Timex T3138 clock radio, locate the "Alarm" or "Alarm Set" button on the front panel. Press this button until the alarm indicator light turns off, indicating that the alarm is unset. If your model has a separate "Alarm Off" button, you can also press that to disable the alarm. Finally, check that the alarm time display no longer shows an active alarm setting.
how do i set the alarm on the lg ally
To stop the blinking light and cancel the dual alarm on a GE radio model 74801A, first press the "Alarm" button to toggle the alarm off. If the light continues to blink, ensure the alarm time is not set; you may need to adjust or reset the alarm settings. Consult the user manual for specific instructions related to your model, as the button functions can vary slightly.
The Koda iStereo iP915 does not have an alarm. You could probably set the alarm on your iPod.