Yes you can connect it out of AUX send. infact that is the best place to connect it from
Yes, you can connect a passive monitor speaker to an EMX 5000.
stereo mixer output to powered mixer input
Yes. In fact, I would recommend doing this instead of just running the mics through your band's powered mixer. That way, all your drum sounds (pre-mixed) will fit into just one input on your band's powered mixer. It takes about a minimum of 6 or 7 mics to capture a drum kit properly and that's a hell of a lot of inputs to be using on your band's P.A. Just run the mics through your own mixer, then run your mixer's "Main 1" output to your band's P.A. input. Use a balanced cable. Also, if the mixer that you are using is unpowered, then get yourself a couple powered monitors to run directly off of it so you can have some monitoring without using one of the the P.A. monitors. If your drum mixer IS powered, however, just get yourself some speakers and you've got yourself some monitors. In a nutshell, I recommend getting a small powered mixer for your drum mics (something with 100W minimum) with unpowered monitors running right off of it (use the "Main 2" output). Connect the mixer's "Main 1" output to your band's P.A. system for the final mix. But remember, if you do it like this, you have to dial in a good mix on your drum mics through your own little mixer because the sound guy will only be able to adjust the volume of the drum kit AS A WHOLE through the main P.A. system. This is what I do and it works very well.
Allen and Heath make a mixer that is just perfect for mixing monitors.
Very few powered mixers have a USB audio connection, but you can connect the line output out of almost any mixer to the inputs on the Mac to record with GarageBand.
anytime...no problems...that's how it should be
To connect an audio interface to a mixer, you typically use audio cables to connect the output of the audio interface to an input on the mixer. This allows you to route audio signals from the interface to the mixer for further processing or mixing.
A powered audio mixer is used for combining, mixing, routing and changing the level, timbre or dynamics of audio signals. They can mix analog or digital signals depending on the mixer.
To connect a mixer to an audio interface, use balanced cables to connect the mixer's main outputs to the audio interface's line inputs. Adjust the levels on the mixer and interface to ensure proper signal flow and avoid clipping.
To connect an audio interface to a mixer, you will need to use audio cables. Connect the output of the audio interface to an input on the mixer using the appropriate cables. Adjust the levels on both the interface and the mixer to ensure proper sound quality and balance.
To connect a microphone to speakers, you will need an audio mixer or amplifier. Plug the microphone into the mixer or amplifier using an XLR cable. Then connect the mixer or amplifier to the speakers using audio cables. Adjust the volume levels on the mixer or amplifier to ensure proper sound output.