answersLogoWhite

0

What else can I help you with?

Related Questions

How a buret is filled up?

To fill a buret, close the stopcock at the bottom, pour the solution into the top of the buret, open the stopcock slightly to allow air bubbles to escape, and then close the stopcock once the solution reaches the zero mark on the scale. Adjust the meniscus by gently tapping the buret if needed.


How to get the hood to release - it is stuck in the up position?

You can use either WD40 or some other lubricant to make it easier to move or gently tap on the hinges with a hammer to loosen them.


How do you remove a rotor to a 1990 Chevy Cavalier?

Pull the wheel, pull the caliper and the rotor comes right off. You may have to tap the back side of it to loosen it up.


When was Loosen Up My Strings created?

Loosen Up My Strings was created in 1997.


How do you unblock a stopcock that is seized up?

If your stopcock on your car's radiator is seized you will probably damage it and ruin the radiator if you try to force it. Leave it alone and drain the water through the lower radiator hose. There is little to gain and a lot to risk in trying to get it to work.


How do you fix a kitchen faucet that won't swivel?

AnswerTry soaking the joint in white vinegar--it might have calcium deposits from the water. Alternatively, check out the website for the type of faucet you have for directions to take it apart, and instructions to replace parts.remove tap from sink and take it apart:1) remove the plastic hot/cold water button that is on the tap leaver that that controls water flow2) under this button you will find where to dismantle the tap (with a screwdriver of Allen key). loosen this then take the tap leaver off3) under this there is a big bolt. Loosen this bolt with a wrench4) then loosen by hand, the part of the tap that should swivel (just above where the spout is connected)5) once this part swivels hold it firmly and re tighten the bolt with a wrench6) this will prevent the swivelling part of the tap tightening up over time7)reassemble the tap and install into sink


How do i remove the cam cover on a Honda crf50 motorbike?

cam cover is on the left side, the bolt that holds it on is on the right side, loosen up the bolt and tap on the bolt will cause the cover to pop off


How to remove rear brake rotors on 2003 Ford Expedition?

The same way you do on the front. If they seem stuck. Tap them with a rubber mallet and try spraying some silicone spray to loosen them up. With a little elbow grease and patience they will eventually come off. Trust me I did it.changing rear brake rotors on 2003 expedThe same way you do on the front. If they seem stuck. Tap them with a rubber mallet and try spraying some silicone spray to loosen them up. With a little elbow grease and patience they will eventually come off. Trust me I did it.


What does loosen mean?

loosened means that like if your shoe is tangled up you loosen it with something


What is the quickest way to loosen your calf muscles?

if after exercise the best way to loosen up would be have a hot bath but if you haven't got access to a bath put your leg up in the air and massage your calf until they loosen up


What is the popposite of stiffen up is?

Loosen up is the opposite of stiffen up.


How do you loosen drive belt on 1989 Nissan 240SX?

loosen the bolt in the center of the drive belt pulley, then loosen the bolt on the side of the pulley. as you loosen the side bolt the tension lets up