How do you use code identification to program 7 in 1 sharper image universal remote control?

Answer 1

I could not get the my Shaper Image 7 in 1 remote to program for my Vizio TV. The included codes did not work and neither did the "code identification" method included in the instructions. Tried these instructions off another website for a Sharper Image Jumbo remote and they worked! I had to hit the power button about 50 times before I hit the right code.

1 -Turn the device on that you want to use with the remote.

2 - Point the remote at the device and press the "Code Search" button the remote. Hold that button down for a few seconds and the LED lights on the remote will turn on.

3 - Press the mode button on the remote for the device you turned on.

4 - Start pressing the "On/Off" button located on the remote. Press "On/Off" once every two seconds until the electronic device powers down. This could take you several minutes because there are hundreds of different codes.

5 - Press "Enter" on the remote after the device turns off to save the code on the remote.

If you push the On/Off button too fast you might zip right past the code you want and have to start over again, so take it slow and concentrate on what you are doing.