What are the codes for a Panasonic television using a dish network remote?

Answer 1

Here are the codes associated with your Panasonic TV: 700, 644, 734, 512, 689, or 510. I have also provided instructions on how to program your Dish remote to your TV.

Address Remote to TV/Other Devices

1. While at the device location (TV, etc), point the remote at the device. Press and hold the device button on the remote (TV, Aux, etc). - All four mode buttons should light up
2. Enter the three-digit remote control code - The mode button (TV, Aux, etc.)you selected should light up

1. Press the Pound (#) button - The mode button you are programming should flash three times
2. Press the large, red POWER button - The device should turn off

Answer 2

Depending upon the type receiver you have, you can connect a cable between your DISH receiver to your Panasonic TV. You can use 4 different types of cable: coax, RCA (red, white, and yellow), component (green, blue, and red - you also need audio cable - red and white), or an HDMI cable.

With a coax cable, you place your TV on channel 3 or 4. Newer TVs need to be on Antenna, TV, or Cable once the channel is set to 3 of 4. Any other type cable is set to an input setting.

Answer 3

I have provided the steps to program the remote below, along with the steps to allow the remote to adjust the surround sound system in TV mode instead of the TV.

Addressing Remote to other equipment:

1.) Press and hold the clear AUX button until all mode lights light up.

2.) Release and TV light will be blinking.

3.) Press 2 for other equipment and enter the code. (if the code is 617, enter 2617)

4.) Press Pound (#)

5.) Try functions (Power, Volume, etc..) and see if it is working.

6.) If no function, repeat steps 1-4 with another code.

AUX Volume Override:

1. Press and hold the AUX mode button until all the mode lights light up.

2. Press Pound (#).

3. Press Volume Up.

4. Press 0.

5. Press pound (#) again.

Answer 4

To control you Television with your Dish Satellite remote you need to perform a power scan to find your remote code. With your Dish Network remote, follow these steps:

1) Turn on your TV

2) Hold down the 'TV' button at the top of your dish satellite remote (the one that lights up) until all 4 buttons at the top light up

3) Press the large red power button

4) Press the channel up (above the select button usually) slowly until the TV shuts off

5) Once your Television powers off, press the pound key '#' (at the bottom of your Dish TV remote)