answersLogoWhite

0

Well audio speakers aremeasured in a few ways but i will explain a few. All speakers are measured in inches or millimeters according to the side, this measurement measure through the center. The frequency is measured in hertz. Then they are all measured in Watts.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How can I fix a damaged speaker in my audio system?

To fix a damaged speaker in your audio system, you can try the following steps: Check the speaker connections to ensure they are secure. Inspect the speaker for any visible damage such as tears or holes in the cone. If there is visible damage, consider replacing the speaker or repairing it if possible. Test the speaker with different audio sources to determine if the issue is with the speaker or the audio system. If the speaker still does not work, consult a professional for further assistance.


What do you mean by 2 way audio system?

it means that the speaker has a speaker cone for the bass and mid frequencies and a tweeter for the high frequencies. this makes it a 2 way audio system. a three way audio system would have a speaker cone for the bass, another speaker cone for the mids, and a tweeter for the highs.


How do you get CD player to produce 5.1?

Connect audio cables to the Audio Out on the DVD player to the Audio In connectors of the speaker system.


Who invented audio speaker?

Alexander Graham Bell as part of his first telephone system.


Which karaoke machine will have the best audio quality?

VocoPro DVDDUET Karaoke System has a good speaker system and controls


What is the recommended gauge of speaker wire for a standard home audio system, specifically for connecting speakers that are a moderate distance apart?

For a standard home audio system with speakers at a moderate distance apart, it is recommended to use 16-gauge speaker wire.


Where do you connect a speaker system to a CD player?

Audio Output Jacks on the back of the CD player


What energy occurs in an audio system?

The electronic energy audio signal is converted to magnetic energy to drive the speakers. The speakers convert magnetic energy to mechanical energy driving the speaker cone. The speaker cone vibrates the air creating audio energy.


What energy transfers occur in an audio system?

The electronic energy audio signal is converted to magnetic energy to drive the speakers. The speakers convert magnetic energy to mechanical energy driving the speaker cone. The speaker cone vibrates the air creating audio energy.


How do you hook up my sony sa-va15 home theater active speaker system to my 32 inch seiki tv?

To connect your Sony SA-VA15 home theater active speaker system to your 32-inch Seiki TV, use an RCA to 3.5mm audio cable. Plug the RCA connectors into the audio output (usually labeled as "Audio Out" or "Line Out") on the TV and connect the 3.5mm end to the input on the Sony speaker system. Make sure to adjust the volume on both the TV and the speaker system for optimal sound. If needed, check the TV settings to ensure the correct audio output is selected.


How can you connect 7.1 speaker to your PC?

To connect a 7.1 speaker system to your PC, ensure your sound card supports 7.1 channel audio output. Use the appropriate audio cables (typically 3.5mm jacks or RCA connectors) to connect each speaker to the corresponding ports on the sound card or audio interface. Additionally, you may need to configure your audio settings in the operating system to enable 7.1 surround sound. Finally, test the setup using audio playback to ensure all speakers are functioning correctly.


1990 Jeep Grand Wagoneer what was the original car audio system?

The Grand Wags had a four speaker cassette player Dolby system.