What is dish network code for auvio remote control?

Answer 1

If you are asking for the code to program the remote to your TV, we need to know the TV brand.

If your remote in not operating the receiver, you can readdress the remote to the receiver. I have provided instructions on how to readdress the remote. You might replace the batteries just to make the batteries are fresh.

• Remote: All Other Remotes
  1. Go to System Info screen (press the Menu button on the remote 2 times).
  2. Hold down the SAT button until all mode lights light up.
  3. Enter a number between 1 and 15 using the numeric keypad on the remote.
  4. Press the pound (#) button.
  5. Once the SAT button blinks three times, press record. Note: If successful, the number selected in step 3 will appear in the System Info screen under Remote Address.

Answer 2

We don't have codes available for the auvio remote yet. I have provided instructions on how you can perform a power scan for the code on your DISH remote. If this doesn't work, I would contact auvio to see if they have a code for you.

Address To Other Equipment Using Power Scan

• Remote: All Remotes (except Basic)
  1. With the desired equipment on, press and hold the correct Mode button until all mode button backlights illuminate, then release.
  2. Press and release the Power button. AUX Mode: Before pressing and releasing the Power button
     • Press 0 for a TV
     • Press 1 for a VCR/DVD
     • Press 2 for any other device
     Then Press STAR (*)
  3. Press the Up button once a second while pointing the remote at the desired equipment. Note: If the code for the equipment comes up, the equipment will power off.
  4. Press the POUND (#) button. Note: If the code entered is valid for the remote, the mode light flashes three times.