The position of the speakers are:
Center: above or below the screen
Right and Left: directly to the left and right of the screen
Right and Left Surround: directly to the left and right of the viewer
LFE (Subwoofer): Anywhere in the room, usually to the left or right of the screen.
The front speakers are composed of a set of component speakers, a 6.5" diameter with a 3.5" mounting depth along with a 1" tweeter with a 1" mounting depth. The back speakers are composed of a set of coaxial speakers with a 6.5" diameter with a 3.5" mounting depth. It also includes an 8" subwoofer with a 4" mounting depth. If you are replacing the speakers just get a set of 6.5" component speakers along with a set of 6.5" coaxial speakers. You don't need to worry about replacing the subwoofer.
51
The rear speakers on a 1999 Buick Regal are removed by accessing the speakers from the trunk. The mounting bolts and then removed, the wires disconnected, and the speakers lowered from their mounts.
The door panel speakers in a 2005 Toyota Corolla are 6.5 inches. These speakers have a mounting depth of 3 inches.
The mounting depth for door speakers in a 1999 Chevrolet S10 is typically around 2.5 to 3 inches. However, it's important to verify the specific speaker model since some aftermarket speakers may require more depth or have different mounting requirements. Always check the vehicle's manual or consult with a professional for precise measurements and compatibility.
To remove the rear speakers on a 2008 Toyota Solara, you will first need to access the speakers by removing the rear seat cushion and the rear side trim panels. Once these are removed, you can then locate and unscrew the mounting screws holding the speakers in place. After removing the screws, disconnect the wiring harness connected to the speakers and carefully pull the speakers out of the mounting location. Be sure to handle the speakers with care to avoid damaging them during the removal process.
i believe the rear speakers are 5x9 and the front are 51/2 round
To replace the front speakers in a Toyota Sienna the door panels must first be removed. With the door panels removed the speakers will be easily accessible and the mounting screws can be loosen. Unplug the speakers and remove them. Install the new speakers.
6.5" with an oddball mounting pattern.
Bookshelf or Satellite speakers are pretty standard for surround sound but they may require wall mounting or specific placement.
the front speakers are 5.25" but the mounting is strange. i used 6.5" speakers and just drilled new holes for the mounting screws. there will be a little gap at the top and bottom...if you're worried about it, you can use dynamat. the rears are 6"x9". the front speakers are 5.25" but the mounting is strange. i used 6.5" speakers and just drilled new holes for the mounting screws. there will be a little gap at the top and bottom...if you're worried about it, you can use dynamat. the rears are 6"x9". Try to use the Chevrolet speaker adapters plugs so you don't need to cut wires and mess up the electric system, you can get those from eBay or amazon
1.6 miles or 4.7 killometers apart for deeper bass