I need to find code for vision quest television
20695
No, the Sony Ericsson P990i does not have an IR (Infrared) port for remote control functionality.
IR (infrared) remote controls are considered line of sight, meaning the remote has to "see" the device it is controlling. An RF remote is not because the signal has the strength to pass through some objects.
Auria TVs use the same codes as NEC. If you lookup NEC in your remote control manual it should work. 10037 will work.
An infrared blaster (or IR blaster) is a device that emulates an infrared remote control to autonomously control a device that is normally controlled only by remote control key presses.IR Blaster is used to change the channel .
Infrared (IR) technology is commonly used in various applications such as night vision devices, remote controls for electronic devices, thermal imaging cameras for surveillance and medical diagnostics, and IR spectroscopy for chemical analysis. IR is also used in automotive safety systems like collision avoidance sensors and in agriculture for monitoring crop health.
Heat lamps and remote control devices.
TVs work with remotes because TVs have an IR sensor on the front bezel for receiving a signal from a remote control. Your Asus monitor is NOT equipped with such a sensor to receive commands from a remote control. It will NEVER work with TV remotes. Not in a million years. Don't even think it.
SInce the Bose uses an RF (radio frequency) remote, and the TV is most likely IR (infra red), you will have to use the IR extenders that came in the box, plug into the IR port on the head, and point the emitter at the IR eye on the device that you are trying to control. This way, you use Bose RF to control the device and get a much better range, and let it convert the commands to IR which the other devices will understand.
You can order the PS2 Remote Control with IR Receiver for use with your PlayStation 2 by visiting the Sony website.
There should seldom be a need to program the DirecTV mode, unless you want to switch to an alternate IR code or RF mode (with an RF capable remote). The default code is 00001, so unless you've previously programmed it for something else there's no need to put 00001 in at all.
You can find instructions to install your wireless remote at your local electronics store. The instructions should be included with the wireless remote.