Go into the menu and look at the SLEEP TIMER. Also if the set is getting too hot it might turn itself off to protect itself. Add a cooling fan.
my stereo turns itself off
When the switch is off, the lights stay on because there may be a problem with the wiring or the switch itself, allowing electricity to continue flowing to the lights even when the switch is in the off position.
On what? this makes no sense.
It must be a faulty kill switch, they don't go off by themselves.
The light stays on when the switch is off because there may be a problem with the wiring or the switch itself, causing the circuit to remain closed and the electricity to continue flowing to the light.
on the break petal itself is a rubber piece that makes contact with the switch that turns your break lights on and off when you use your break. this most likely has fallen off making the switch think you are constantly pushing the break to fix find something about 3/4 of a inch tall and glue it to the place on the petal so it will make contact with the switch when you let off the break hope this helps
If you are talking about a wall switch for the heater, check to see if the heater has its own internal thermostat or switch as this might be in the off position and not allow the heater to turn on. If you are talking about a switch on the heater itself, then yes in all probability the switch is not working.
Hey Lain==They are on the headlight switch so the headlight fuse should turn them off. The problem is probably in the switch itself. GoodluckJoe
Yes, a 1999 Toyota Camry does have an emergency fuel shut off switch. The switch is actually built in the car and will shut off itself during an accident.
The light may not be turning off with the switch due to a faulty switch, a problem with the wiring, or a malfunction in the light fixture itself. It is recommended to check the switch, wiring, and fixture to determine the cause of the issue and address it accordingly.
Either there is a loose connection where the wires are attached to the switch, or there is a bad connection inside the switch itself. Turn the breaker off that controls that switch. Remove the cover plate. make sure the wires are tightly connected. If they are tight, replace switch.
It could be the high speed heater motor relay is stuck on or the switch itself is broken.