answersLogoWhite

0

A Gen 3 rear axle may not fit a Gen 4 vehicle due to differences in design, dimensions, and compatibility of components between the two generations. While some parts may be similar, specific measurements and mounting points often vary. It's essential to consult the manufacturer’s specifications or a professional mechanic to confirm compatibility before attempting any swaps.

User Avatar

AnswerBot

1w ago

What else can I help you with?

Related Questions

Will a rear axle from a 1994 z28 Camaro fit in a 1990 rs Camaro?

No. The 4th gen rear end is 4 inches longer.


Will a fourth gen camaro rear end fit in a 3rd gen camaro?

Yes but it will stick out about 2" on each side. Which is good if your running 4th gen rims. Otherwise itll look funny.


Will fifth gen Camaro rims fit a third gen Camaro?

I believe that the 5th gen 20'' rims will fit the 3rd gen Camaro. i know that they will fit the 4th gen so should fit the 3rd


Will a 454 engine fit on a 81 Pontiac transam?

hotrod years ago stuffed a bb in a third gen camaro...it'll fit...but you better get a way stronger rear end!-i guess even the best of the third gen's rear axles not even as strong as the weakest 70's 10 bolt.....


Does a civic rear bumper fit on a crx?

Will a 90 crx rear bumper ant mount fit an 89 DX hatch?


Will a gen 1 front fit on a gen 2 Lincoln mark viii?

gen does fit on top of jacob To fit you will need to do extensive work.


Will seats from a second gen CRX fit a first gen CRX?

the seats are from a 1988-1991 Crx(2nd Gen) and i wanted to know if they would fit a older Crx 1984-1987(1st gen)


Will 3rd gen camaro rims fit 4th gen camaros?

Yes


Does 2nd gen itouch screen fit on 3rd gen itouch?

Yes it does.


Do seats from a third gen camaro fit in a fourth gen?

The seats in my third gen (88 iroc) came from a 4th gen. No modifications.


Will a 1987 s10 blazer rear end fit on a 2002 s10 blazer?

The "S10" and "K5" nomenclatures were dropped after 1994... the K5 was replaced by the Tahoe, and the 2nd gen follow up to the S10 Blazer was simply the Blazer. If you're referring to the rear end of the body and/or chassis, the answer is no.. very different platforms between Gen 1 and Gen 2 models. If you're talking about rear end gears, yes, but you'll want to check the RPO codes to ensure the ratios match. If you try engaging four wheel drive and your replacement axle has, say, 3.73 rears, while the front has the standard 3.42s, expect something to go "crunch" really quickly and cost a lot to repair.


Can an iPod touch fourth gen charger fit the fifth gen?

No because the 5th gen charger is small and 4th gen charger is big