answersLogoWhite

0

The issue is likely related to the headlight switch or the dimmer switch on the steering column. If the high beams only work when the stalk is pulled forward and the indicator remains on, it could indicate a faulty switch or a wiring problem. Additionally, check for any blown fuses or poor connections in the headlight circuit. Testing the continuity of the wiring and connections will help identify the exact cause.

User Avatar

AnswerBot

2mo ago

What else can I help you with?

Related Questions

Where is the full beam headlights on an x reg vauxhall corsa?

Push the indicator stalk forward


How do you adjust the headlights on your 1994 960 Volvo?

I assume you mean the angle of the headlights and not the brightness. On the headlights themselves are Allen screws with measurement markings and angle degrees. Loosen Allen screw and move bolt forward or backward to change angle.


How do you raise and lower the headlights of a 1993 Ford Probe?

Answer: on the turning signal switch turn the handle forward for headlights. high beams pull in to flash. push out for high beams to stay on.


How do you change indicator lens on vw t4?

Very easy, open the bonnet. On the indicator you will see a tab. Simply gentle lift the tab and slide the whole indicator forward. The lamp holder will come out with a twist.


What xenon headlights are legal?

depends on your area and local laws, technically only original equipment lights are legal, that being said most laws only dictate that the forward headlights be white in colour.


1988 Toyota pickup with no low beams and only High beams when the switch is pulled forward Also the high beam indicator is always on when turning the headlights on yet no lights are actually on How ca?

First double check the bulbs to be sure they are good then I would suspect the high/low beam switch or the headlight switch is at fault.


What is the problem if the high beams come on but won't stay on when the switch lever is released on a 95 jetta?

On a 95 Jetta you push the lever forward to keep the highbeams on pulling it is just to flash them. also make sure you have the main light switch turned on as well.


How do you remove front fog light citroen synergie?

If it's just the bulb you are replacing it is done by removing the indicator (unhook the spring in the engine compartment and slide the indicator forward). If you need to replace the whole lamp then the bumper has to be unbolted!


How do you change the Headlights on a 1996 Cavalier?

Take out the 2 bolts on top of light assy and lift up and forward. There is a tab on the bottom that slips into a slot when you put it back in.


How do you turn the bright lights on in my 1994 Ford Explorer?

Try pushing your turn signal lever forward , that's what I do to turn on my high beam headlights on my 1995 Ford Explorer


How do you use the bright lights in a Crown Victoria?

You don't say what year of Ford Crown Victoria , but if you move the turn signal lever forward it will turn on the high beam headlights


How do you operate the beams on a 1998 Crown Victoria?

On a 1998 Ford Crown Victoria : If you mean that you want to turn on the high beam headlights ( push the turn signal lever forward , away from you )