answersLogoWhite

0

If you pull the bolt next to the oil dipstick out of the power steering unit it will give you plenty of slack to get the belt off.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Can't get trunk to stay shut I must slam it many times and sometimes that doesn't work 1995 corolla dx?

Try adjusting the bracket on the stationery locking mechanism - it has loosened or become dislocated.


Your dealership broke the steering column locking mechanism on your 2001 Jeep Cherokee They insist there is no steering column locking mechanism?

Answer: The dealership is correct. The 2001 XJ does not have a steering column locking mechanism.


Does a Jeep Wrangler 2012 have a locking steering column?

No.No.


Would steerin fluid effect your steering wheel from locking?

If the power steering fluid leaks out the steering would become very stiff, and perhaps "lock" if the car were parked.


What is Code 32 for airbags in a 1997 Mercury Cougar?

It is an open circuit in the drivers airbag. There is a clockspring behind the steering wheel that may be worn. To replace, remove airbag, steering wheel, column covers, and lower dash cover. MAKE SURE WHEELS ARE STRAIGHT. The new clockspring comes centered with a yellow locking tab. Remove that after installing it.


Why is your automatic car stuck in park?

This sometimes happens when you park your car with the steering wheel turned too far to the right or to the left locking the steering wheel and trans. in park.


What is the fix for a broken tilt steering locking mechanism in a 2002 Mercedes C240 and does the entire steering column need replacement at a cost of 2000 dollars?

the steering column tilt and telescoping lock does not keep wheel in place. How do I fix this ?


Your trunk will not lock it you shut it it will pop back open?

Try lubricating lock mechanism Try adjusting mechansim Replace locking mechanism


How do you fit a astra 2002 sxi ignition barrel?

Remove the cowlings from the steering column around the lights/indicator stalks. Insert key and turn to position "I",push in the locking pin on top of the lock barrel with a small screwdriver and withdraw the locking assembly.Take the new lock and set to "I" again,if steering lock was not released before starting the removal,you may need to push down the steering blocking pin with a screwdriver down the hole.Otherwise,just insert the locking assembly until it clicks in.


Cannot get locking plate ring back in place on 94 gmc steering wheel don't know the order it goes underneath the locking plate?

If you are asking about the small circlip that holds the locking plate down, it goes on top of the locking plate. There should be a spring on top of the turn signal cam then the locking plate goes on top of that. A special locking plate depressor is required to hold the locking plate down, then the circlip holds the locking plate in place when the depressor tool is removed. Hope that makes sense and works for you.


How do you remove the rear door panels on your 1994 Mercury Grand Marquis They are shut and will not open the locking mechanism has fallen down inside the door?

How do you remove the rear door panels on your 1994 Mercury Grand Marquis They are shut and will not open the locking mechanism has fallen down inside the door?


How would you remove a 1998 Peugeot 106 Zest 2 steering wheel which doesnt have power steering?

You need to undo the two locking pins on the side, then take the steering wheel off, only in a straight angle. Dont forget to remove the casing aroung the steering column