plug in scan tool or code reading into OBD2 DLC 16 pin connector above right knee.
press reset DTC.
done.
To reset the service engine light on a 1997 Suzuki Sidekick first turn off the car. Unplug the battery of at least 5 seconds and then plug the battery. The computer will now be reset.
On my 93 suzuki sidekick the check engine light came on at exactly 120000 miles.It can be reset if you take your drivers side speaker out you'll find a switch in there to reset it.If the problem occurs again then you probably have a real problem.If you vehicle is not running any different then I wouldn't be that concerned.
Usually a problem in the emission control system - have vehicle scanned to determine the problem
There are a couple of ways to reset the Service Engine Soon light on a Suzuki Grand Vitara. The easiest way is to get a scan tool from your local auto parts store. Using the scan tool will reset the service engine light. Disconnecting your vehicle's battery is another way that often works to reset the Service Engine Soon light.
The check engine light on a Suzuki Sidekick, like in most vehicles, can illuminate for various reasons, including routine maintenance needs or issues with the engine or emissions system. It doesn't typically come on at a specific mileage but may trigger after reaching certain intervals if maintenance reminders or diagnostic trouble codes are present. Regularly checking the vehicle's diagnostics and maintaining service schedules can help prevent unexpected alerts. If the light comes on, it's advisable to have the vehicle diagnosed to determine the underlying issue.
get the CEL checked and fix the problem. Disconnecting the battery for 15 minutes will reset the light on an OBD1 vehicle.
To retrieve engine codes from a 1992 Suzuki Sidekick, you need to locate the diagnostic connector, typically found near the driver's side under the dashboard. Use a jumper wire to connect terminals A and B on the diagnostic connector, then turn the ignition key to the "On" position without starting the engine. The check engine light will blink a series of codes that correspond to specific diagnostic trouble codes (DTCs). Count the blinks to identify the codes, which can then be cross-referenced with a service manual for interpretation.
meaning something's wrong with your engine, go to your car shop and have it diagnosed.
To reset the service light on a Suzuki Splash, turn the ignition to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. After doing this, turn the ignition off and then start the engine; the service light should be reset. If the light remains on, repeat the steps or consult the owner's manual for further instructions.
Because of an electric fault
Yes I have only seen it in my car once
There are pages and pages and items that can cause a check engine light. You need to have it checked for codes with a scan tool. After repair light can be shut off with scan tool.