Normal operation. You may have been accelerating on a slippery/snowy surface and that system stops you from loosing control of vehicle. It is the traction control system preventing your wheels from spinning out.
Vehicle Scid Control
The underside of the throttle body.
The Lexus RX300 comes with a range of good features such as air conditioning, climate control, cruise control, power steering, heat reflective glass and electrical sunroof.
Have vehicle scanned to determine problem and reset
You have light bulb that is burned out at the back of the vehicle.
I had a similar problem with my RX300 2002. I just replaced the bank 1 sensor 1 and bank2 sensor. These are Air Fuel ratio sensors which are found before the catalytics converters. Hope it will solve your problem
In a 2001 Lexus RX300, each service light on the dashboard indicates different maintenance or operational issues. The "Check Engine" light signals potential engine or emission system problems, while the "Oil Pressure" light indicates low oil pressure, which could suggest a need for oil change or a leak. The "Battery" light warns of charging system issues, and the "Brake" light can indicate a problem with the braking system or that the parking brake is engaged. Always refer to the owner's manual for specific meanings and recommended actions.
low tire pressure
how do you remove the glovebox in an rx300 lexus 2002
Remove the throttle body. Remove the 4 IAC mounting screws. Remove the IAC.
A blinking check engine light on a 2000 Lexus RX300 typically indicates a severe engine issue, such as a misfire, which can lead to significant engine damage if not addressed promptly. It's essential to stop driving the vehicle and have it diagnosed by a professional mechanic as soon as possible. They can retrieve the diagnostic trouble codes (DTCs) to identify the specific problem and recommend necessary repairs. Ignoring this warning can result in costly repairs and decreased vehicle performance.
To change a fog light on a Lexus RX300, first, ensure the vehicle is turned off and the keys are removed. Open the hood and locate the fog light assembly, typically accessed from behind the bumper. Disconnect the wiring harness from the fog light, then twist the fog light bulb socket counterclockwise to remove it. Replace the old bulb with a new one, reassemble the socket, and reconnect the wiring harness before testing the light.