dist timing off. Disconect power to distribtor wire, remove no1 plug put finger in plug hole when u feel tha air pushing against it . Bring timing mark to 0o TDC, rotor should b pointing to number 1 plug wire on cap.
On top of the engine in back of the throttle body.
The distributor cap on a 96 gmc sonoma is located on the top of the engine towards the back, behind the throttle body next to the firewall.
A throttle position sensor might keep the engine from starting. Any number of things can cause a vehicle not to start. The starter and the gas line sensors are also a possible culprit.
could be distributor cap or rotor
The 5.9L V8 only had egr in 1995 and before. It was located behind the intake next to the distributor on a multiport fuel injected engine, and on the side of the intake on a throttle body injected version.The 5.9L V8 only had egr in 1995 and before. It was located behind the intake next to the distributor on a multiport fuel injected engine, and on the side of the intake on a throttle body injected version.
if its a 4v it under the valve cover. if its a 2v it is on top of the half distributor at the rear of the engine under the throttle body.
Just fixed this problem on a 1990 4.3. The pickup coil inside the distributor was bad. No signal was sent to computer to fire injectors. Make sure distributor is grounded well and if there is corrosion visible inside distributor save time and frustration by just replacing the distributor. I found several new ones on eBay for under $100. Had spark enough to run on starting fluid or if I poured gas in the throttle body but the injectors had no signal if checked with NOID light.
The distributor is on the front of the engine.
The 1991 BMW 520 distributor Can be found on the back side of the engine. The distributor Will be on the top of the engine.
7mgte doesnt have a distributor. it has coil packs. only 7mge has distributor
To install the throttle cable on a 1994 Oldsmobile Cutlass Sierra, first, ensure the engine is off and the ignition key is removed for safety. Locate the throttle body and detach the old cable if necessary, then thread the new throttle cable through the firewall and into the throttle body assembly. Connect the cable to the throttle lever, ensuring it is properly seated, and adjust the cable tension as needed. Finally, secure any clamps or brackets and test the throttle operation before starting the engine.
1342 it is on the distributor cap. And pistons are 1234 starting from pulley side of the engine.