the alpine 7914 is pre-amp only you need a amp
To remove a magnet in a speaker, first detach the grill in the front of the speaker, second unscrew the speaker after that remove the speaker from the cabinet and cut the speaker cone. Lastly, gently discard the magnet from the speaker cone.
Door Speakers: * Remove the door trim panel * Remove the speaker mounting screws * Pull out the speaker and disconnect the electrical connector from the speaker and remove the speaker Door Subwoofers: * Remove the subwoofer grille trim panel * Remove the door trim panel * Remove the 8 mounting screws from the front side of the subwoofer * Remove the single subwoofer retaining screw from the backside of the subwoofer enclosure * Pull out the subwoofer,disconnect the electrical connector and remove the subwoofer Quarter Panel Speakers: * Remove the quarter panel trim * Remove the 4 speaker mounting screws * Pull out the speaker,disconnect the electrical connector and remove the speaker Parcel Shelf Speakers: * Working from inside the trunk area,disconnect the speaker electrical connector * Remove the parcel shelf * Remove the speaker mounting screws and remove the speaker
Remove speaker grill, remove screw holding speaker, screws to the mirror are behind speaker
The speaker covers are held in with a screw, remove it and tilt it out away from where the screw was. then remove the screws holding the speaker in and remove the speaker.
You do not need to remove the door panel to change your speakers. Remove the speaker cover, by prying outward on the speaker cover retaining clips. Remove the speaker retaining screws. Remove the wiring harness from the back of the speaker.
from shop manual: remove luggage cover and holder assembly remove speaker cover retainer nut and and screws securing the cover in place over the speaker assembly loosen and remove the speaker retainer screws securing the speaker in place, lift the speaker out enough to access the wire harness at the rear of the assembly disconnect the speaker harness remove the speaker installation is the reverse of removal
REAR SPEAKER - JR41 Disconnect and isolate the battery negative cable. Fold down the rear seat backs. Remove C-pillar trim. Remove lower quarter trim behind rear seat backs. Remove fasteners from rear shelf trim. Pull out trim to access speaker. Remove speaker screws. Disconnect wire harness connector. Remove speaker (REAR SPEAKER-JR41). REAR SPEAKER - JR27 Disconnect and isolate the battery negative cable. Using a trim stick, pry the speaker grill from the trim panel. Remove speaker mounting screws (REAR SPEAKER - JR27). Remove speaker from trim panel. Disconnect wire harness connector from speaker.
The 1990 Chevy Corvette front drivers side speaker cover will need to be removed. Remove the speaker retaining screws. Remove the wiring harness from the back of the speaker.
Begin by removing the speaker covers in your 2006 Toyota. Remove the speaker retaining screws. Remove the wiring harness from the back of the speaker.
Remove the speaker covers, by loosening the retaining screws. Remove the speaker retaining screws. Remove the wiring harness. The speakers will come out.
YOU WILL HAVE TO REMOVE THE REAR SEATS. THE SPEAKER GRILLS AND THE PANEL IN THE WINDOW IS ONE PIECE.
You will need to remove the rear door speaker covers. The Chevrolet blazer speaker covers are held in place with two retaining screws. Remove the speaker retaining screws. Remove the speaker wiring harness.