No, just one.
The fuel tank on a 1994 full size K15 blazer is 30 gallons.
Inside the tank.
where is the fuel pump located and how to remove it on 1994 Chevy S10 blazer
41 to 47 psi.
are there 2 fuel pumps on a 1984 chevy citation
Where is the location of fuel pump relay on 1996 Chevy Blazer?
How do you replace fuel injectors on 2003 Chevy blazer?Read more: How_do_you_replace_fuel_injectors_on_2003_Chevy_blazer
To replace the fuel injection spider on a 1994 Chevy Blazer, first, disconnect the negative battery cable and relieve the fuel pressure by removing the fuel pump fuse and running the engine until it stalls. Then, remove the intake manifold, disconnect the fuel lines, and take out the old fuel injector spider assembly. Install the new assembly, reattach the fuel lines, and reassemble the intake manifold before reconnecting the battery and testing the system. For a detailed diagram, refer to a repair manual or online resources specific to the 1994 Chevy Blazer.
First make sure the fuse to the fuel pump is good then pull the fuel supply line to the carb and turn the key on and see if fuel pumps out (note: make sure you have a bucket the catch the fuel.) If fuel pumps out, the fuel pump is fine, if not than it may be bad.
While both the Chevy S10 and 2001 Chevy Blazer may share similar engine components, fuel pumps can vary significantly between models due to differences in fuel systems and design. It's important to check the part numbers and specifications for both vehicles to ensure compatibility. Additionally, consider factors like pressure ratings and electrical connections before attempting to swap the fuel pumps. If in doubt, consult a mechanic or refer to a service manual for guidance.
The fuel gauge fuse on 1998 Chevy blazer is located in the front of the blazer. It is on the driver side next to the hook latch.
How do you wire a Pigtail for a Fuel Pump on a 97 Chevy Blazer Thank You EVa