0
What else can I help you with?
Break lights not working?
if the bulbs are not bad, it is the fuse, if the fuse is good, its the wiring.
No brake lights on you cavalier 1994 fuse working?
cavalier break lights not workin no indicators neither help fuseis gud do i need to change panals were bulbs go or what????????????
What are the advantage to a parallel circuit?
If one wire was to break only one of the bulbs on the circuit would stop working whereas if one wire broke on a series circuit all the bulbs would stop working.
Hazard warning lights not working but left right turn signeles working peugeot 106?
If the bulbs are working then you just need to change te fuse.
How do you change a Mitsubishi lancer dome light?
remove the broken one and replace with a new and working bulbs.
How do you change bulbs in a 1997 Blazer?
There are many bulbs on a vehicle, need to know which bulbs you want to change.
1991 Toyota corolla front blinkers and hazards not working but my back blinkers and hazards are working all other lights are good and working my fuses are good?
Change front light bulbs
How do you fix a car blinker that is not working but the hazards are working fine?
Check/change the fuse associated with the blinkers.
What should I do with light bulbs that are no longer working?
You should recycle light bulbs that are no longer working to prevent harm to the environment.
Why are your dodge caliber brake lights not working?
1- Check your fuse 2- Check your voltage output to your bulbs 3- Reset your TIPM (remove both connector on your battery for 10 minutes) If nothing work, you can spliced your break hatchback connector (if still working) and connect your brake light... Or change your TIPM.
Why do your breaklights stop working?
Your break lights could stop working for several different reasons. First statr by checking your fuses, if they are good then check the bulbs, If both of those things are ok then look to see if your break switch is operating properly, it may be stuck.
How do you change turn signal bulbs on 1992 dodge Dakota?
Phillips screwdriver undo screws take off plastic pannel, Push bulb and turn to get it out. Be careful the bulbs like to break when taking them out.
