0
What else can I help you with?
How do you fix a knock sensor on a 1996 Mazda millenia?
It is a nonservicable part, just replace it.
Why when you push gas peddle Mazda Millenia takes of slow and RPMS go up fast?
bad knock sensor
Where is the knock sensor located on a 1999 Mazda Millenia 2.5 engine?
Most knock sensors are located in the block on the firewall side. Should be the only sensor with two wires in the block. It will also have a camshaft position sensor as well. Hope that helps. I am not educated on Mazda engines.
Where are the Oxygen sensors for Mazda millenia and how many are there?
Depends on Which Year and Which Engine (2.3 or 2.5) My 99 2.5L has 4 o2 PLUS a knock sensor
Where is the knock sensor located in a 1997 Mazda Millenia and how long does it take to replace?
In a 1997 Mazda Millenia, the knock sensor is typically located on the engine block, near the intake manifold, often on the driver's side. Replacing the knock sensor usually takes about 1 to 2 hours, depending on your mechanical skill and whether any additional components need to be removed for access. It's important to ensure that any necessary gaskets or seals are replaced during the process to prevent leaks.
Where would the knock sensor be located on a 2004 Mazda 6?
Where would the knock sensor be located on a 2004 mazda 6?
Where is the knock sensor located and how hard is it to replace on a 2001 Mazda Millenia?
29's here i have a 97 Mazda millenia 2.5 and have had the knock sensor replaced. all the Mazda 2.5 motors 95-02 are the same so i can tell you that its located in the center of the engine only accessible from the top of the motor underneath the intake and fuel rails (which have to be removed in order access the sensor). the gasket for the intake can not be reused and must be replaced. this a repair that a standard mechanic should be able to perform. hope this helps. It is underneath the supercharger support bracket on the 2.3L.
What parts need to be removed when changing a knock sensor for a 1997 Mazda millenia-2.5?
air intake hose,accelorator cable,fuel pipes ,pipe,harness,egr valve,intake manifold,bypass pipe,water pipe,and knock senser
What are the most common problems with 1998 Mazda Millenia S?
most Ive seen and experienced are - TCS Light - Knock Sensor Failure - O2 Sensor Failure(s) - Auto Steering tilt Failure (motor) - ECG Valve failure
How do you change and where is the location of the Knock Sensor on a 1998 Mazda Millenia?
29S HERE, ONLY 97 AND 98 MILLENIAS HAVE THE EXACT SAME MOTORS. I HAVE A 97 AND I HAVE REPLACED MY KNOCK SENSOR WHICH IS LOCATED IN THE CENTER OF THE ENGINE BELOW THE INTAKE. IT WILL REQUIRE THE REMOVAL OF THE AIR INTAKE AND NEW INTAKE GASKETS YOU CANNOT REUSE THE OLD ONES.
Where is the knock Sensor on a 1995 Mazda B4000 truck V-6 4.0?
I don't think it has a knock sensor ( I know that the 4.0 liter V6 engine in my 1995 Ford Explorer doesn't have a knock sensor )
Where is the knock Sensor on a 1995 Mazda B4000 truck V 6 4.0?
I don't think it has a knock sensor ( I know that the 4.0 liter V6 engine in my 1995 Ford Explorer doesn't have a knock sensor )
