answersLogoWhite

0

With an after market intake manifold or go 2 a bone yard and get an pre 87 sb intake and have the 4 center holes drilled straight down. earlier manifolds holes were drilled at an angel. If your vehical is a pre 87 then that's all u have 2 do. it would Be easy just to keep the TBI set up 87 or later. Better fuel millage.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

What year is your 350 Chevy engine 14093638?

87-95


What is the engine year with a cast number of 14093638?

1986-94 Chevy 350.


Is The casting number of 14093638 a lt1?

What type of engine is 14093638


What size motor has block casting numbers 14093638?

chevy 350


What does g638 on the side of the block above the starter mean casting is 14093638?

http://nastyz28.com/chevy-engine-code-stampings.phphttp://chevroletforum.com/forum/general-tech-10/engine-casting-vin-decoding-22262/


How do you adjust carb on 1999 Chevy Metro 1.0 liter engine?

My 1999 Chev. Metro has fuel injection. I doubt that any of them were carbureted.


How do you make an engine harness to install a 1986-94 350 TBI Chevy engine in an older carbureted vehicle?

You would need to carry over the entire harness including computer from the TBI engine.


What year was the last 350 Chevy motor to be carbureted?

1986


Does the 1987 Caprice Classic 5.0 carbureted have a Chevy 305 engine or an olds 307?

A 1987 Chevy Caprice Classic with the original engine does have a carb and the engine is a 305, because I have one. This can have a 307. I have an 87 Caprice Estate Wagon, with a 5.0 liter 307 olds. Which, is actually for sale.


What distributor do you need for a carbureted 2.8 V6 Chevy engine?

For a carbureted 2.8 V6 Chevy engine, you typically need a distributor compatible with the GM HEI (High Energy Ignition) system or a traditional points-style distributor, depending on the specific setup of your engine. The HEI distributor provides better spark and is often preferred for its reliability and performance. Ensure that the distributor matches the engine's firing order and is compatible with the ignition coil and other components in your ignition system. Always consult your engine's specifications or a service manual for the exact part numbers and compatibility.


Is the 1993 Chevy G30 motor-home fuel injected?

The 1993 Chevy G30 motorhome typically came with either a carbureted engine or a fuel-injected engine, depending on the specific model and configuration. Many models were equipped with the 5.7L V8 (350 cubic inches) that was available with fuel injection. However, it's essential to check the specific vehicle details, as some earlier models may have retained carbureted engines.


Is the 2000 Ford Expedition engine carbureted?

No , fuel injected

Trending Questions
What does the green arrow mean on a transit dashboard? Can you replace 5 amp fuse to 7.5 amp fuse from the air condition? When to replace the timing belt on a 2006 Chevy HHR? How can you tell if a car stereo is going to have good sound quality? Can you use PH3675 oil filter in an 03 Yukon XL although it has anti drain back valve which the recommended PH3506 does not? How much coolant does an 01 crown vic hold? What made your blinkers and brake lights stop working hazards to? What is the valve setting on a Cushman Truckster with 22 hp OMC engine? Is it illegal to pump gas in a running car? Why do the windshield wipers and headlights come on when you hook the battery cable to the negative terminal on the car battery after replacement? Can a 13a fuse be used in a plug that takes a 3a fuse? Can an electrical spark mixed with gas cause a fire? What is the pump clutch in a car? What is the fram air filter cross reference for cub cadet part number ma10310511200? How do you fix P0420 catalyst efficiency below threshold? Why are wooden sleepers used below the rails? Where is the evap control system canister vent solenoid circuit malfunction located in a 2004 Chevrolet Suburban? How do you change fuel filter on 2004 mini cooper? What next 1999 gmc sierra 4.3 wont start turns over not getting fuel fuel pressure 60 when turning over drops to 52 changed regulator crank sensor distributor cap and rotor fuel filter? Where is the location of crankshaft position sensor on a 2006 Chevy Silverado HD?