answersLogoWhite

0

Yes, a timing belt tensioner can make noise if it is worn out or malfunctioning. Common sounds include rattling, squeaking, or grinding, which may indicate that the tensioner is not maintaining proper tension on the timing belt. If left unchecked, a noisy tensioner can lead to belt slippage or damage, potentially causing engine performance issues. It's advisable to have it inspected and replaced if necessary to prevent further problems.

User Avatar

AnswerBot

1mo ago

What else can I help you with?

Related Questions

Can a bad timing belt make noise?

Yes, a bad timing belt can make noise. If the timing belt is worn, loose, or damaged, it may produce a ticking or slapping sound as it interacts with other components. Additionally, if the timing belt tensioner or pulleys are failing, they can also contribute to unusual noises. It's important to address any noise promptly, as a failing timing belt can lead to serious engine damage.


How do you fix a high pitched squeaking sound from drive or timing belt on 94 Geo Metro?

It's probably the drive belt and they tend to make noise when they are getting stretched. You can either try tightening it, if it is able to be and not have a tensioner assy, or replace the belt.


Why does your Saturn Ion 2003 make a loud noise when you start it?

iwhat does the noise sound like. most likely a worn belt or belt tensioner if its a high pitched squealing noise.


How do you loosen the tensioner on the timing belt?

You will need to tell the year, make and model. All are different.


Will bad timing chair tensioner cause top end noise On 2005 Polaris predator 500?

yes, if the tensioner is bad it will make a noise at idle, but when you rev it up the chain will get tighter and the noise will go away.


What does a bad timing belt sound like?

When a timing belt is going bad it can make a high-pitched screeching sound. It can sound like a high-pitch whirring noise. Not all timing belts make a noise when they are worn or going bad.


Why would an Explorer make a squealing noise when you start it?

Assuming you have already checked the obvious, the serpentine belt tensioner and belt. A common cause of the squeal in 4.0 Ford engines is the camshaft sychronizer (takes the place of the distributor on DIS, distributorless ignition systems). It sounds very similar to a belt squeal and is often mis-diagnosed as a belt being loose or worn. The noise can be intermittant, but if the noise is there when you have the hood up use a simple mechanic's stethoscope to help pinpoint the source of the noise. == == The most likely culprit is a serpentine belt or the belt tensioner. Try replacing the serpentine belt. If the noise persists, replace the belt tensioner. See the related article "Serpentine belt and Tensioner FAQ for the Ford Explorer all models"


Why is it so hard to tighten up the timing belt?

You just need to remove the bottom cover on the side where the timing belt is. Then loosen up the bolt on the tensioner, then use pry bar then when when the belt is tight, tighten the tensioner back up. (make sure Your TDC (Top Dead Center)) ;)


Noise at idle after timing belt replaced?

Check all belts and anything that was removed while changing the timing belt, to make sure that nothing was damaged. If everything is ok, then the timing belt may be loose.


Is Chevrolet Aveo a good vehicle?

we have one and what the dealer fails to tell you is that the timing belt needs to be replaced at 60,000 miles, We found out the hard way and it cost us 3,000 the tensioner failed and it destroyed everything,tensioner,timing belt,shroud cover,belt valves, rods,serpinteen belt,,Make another choice


How do you change a timing belt on a 85 Honda civic?

Loosen the timing belt tensioner so the belt will have some slack before removing it from a 1985 Honda Civic. Remove the old belt. Install the new belt and make sure the engine is TDC.


Should the distributor make a ticking noise?

If your vehicle has a timing belt and not a chain, you need to replace it immediately. My distributor made the same ticking noise and it turned out to be the timing belt had a frayed piece on it and this piece was the source of the noise. Before I could figure it out, the belt broke and left me stranded on the roadside.