0
What else can I help you with?
What would cause the following codes to come up on a 1995 Mazda Millenia P0325 P1601?
P1601 code means there is an error on the Powertrain Control Module Communication Line to TCM PO325 code means there is a fault in the Knock sensor circuit
How do you fix a knock sensor on a 1996 Mazda millenia?
It is a nonservicable part, just replace it.
Will the knock sensor cause the car not to start?
No it will not. The knock sensor is used to adjust the timing.
Why when you push gas peddle Mazda Millenia takes of slow and RPMS go up fast?
bad knock sensor
Can knock sensor cause spark knock?
yes when it is not working properly
Where is the knock sensor located on a 1999 Mazda Millenia 2.5 engine?
Most knock sensors are located in the block on the firewall side. Should be the only sensor with two wires in the block. It will also have a camshaft position sensor as well. Hope that helps. I am not educated on Mazda engines.
Will old plugs cause a knock sensor code?
No it will not.
What is a 2000 Toyota Avalon Fault code PO330?
I was told at Autozone it is a Knock Sensor Circuit
What can happen if a knock sensor is bad?
the motor could pre-detonate or "knock" that can cause damage
Where are the Oxygen sensors for Mazda millenia and how many are there?
Depends on Which Year and Which Engine (2.3 or 2.5) My 99 2.5L has 4 o2 PLUS a knock sensor
Where is the knock sensor located in a 1997 Mazda Millenia and how long does it take to replace?
In a 1997 Mazda Millenia, the knock sensor is typically located on the engine block, near the intake manifold, often on the driver's side. Replacing the knock sensor usually takes about 1 to 2 hours, depending on your mechanical skill and whether any additional components need to be removed for access. It's important to ensure that any necessary gaskets or seals are replaced during the process to prevent leaks.
Would a knock sensor cause the engine to run rich?
No it will not.
