yes very
No, the fluid cannot absorb water but you can get water in your brake system and that would be bad. --Most brake fluids used today are glycol-ether based. Glycol-ether brake fluids are hygroscopic (water loving), which means they absorb moisture from the atmosphere under normal humidity levels. Racing brake fluid may be synthetic and not have this problem, but in the everyday world, brake fluid does absorb water.
Yes.
There is no substitute available that can be used for brake fluid. Using anything other than brake fluid could be dangerous and would likely cause damage.
Most Brake fluid is made of Glycol-ether. (Dot 3 being the most common). But mineral spirits is used in rare dot 5. Brake fluid is not considered hazardous until it is contaminated by other properties found in a brake system such as dust or metal.
Air unlike brake fluid can be compressed. When there is air in the brake system it compresses when you apply the brakes. This causes a loss of brake pressure on the brake pads and results in much longer stopping distances. This is dangerous and will cause an accident.
the average boiling point of the brake fluid has dropped to a potentially dangerous level because of moisture contamination and may not meet minimum federal requirements for brake fluid.
it doesnt matter why would you drink it?
the average boiling point of the brake fluid has dropped to a potentially dangerous level because of moisture contamination and may not meet minimum federal requirements for brake fluid.
No, brake cleaner should not be used as starting fluid. Brake cleaner is not designed for use as a starting fluid and can be dangerous if used in this way. It is important to use the correct type of starting fluid for your vehicle.
Brake fluid is made from glycol ether because it has excellent properties that enhance braking performance, such as a high boiling point and low viscosity. Glycol ethers also provide good lubricating qualities and help prevent corrosion within the brake system. Additionally, they are hygroscopic, meaning they can absorb moisture, which helps maintain consistent braking performance even in varying conditions. This combination of properties makes glycol ether an ideal choice for formulating reliable and effective brake fluids.
Ether your low on brake fluid, or you have the wrong kind in it.
No, starting fluid should not be used as brake cleaner. Brake cleaner is specifically designed to clean and degrease brake components, while starting fluid is used to help start engines. Using starting fluid as brake cleaner can be dangerous and may not effectively clean the brakes.