0
What else can I help you with?
Can replacing air filter cause the air fuel sensor heater circuit response to malfunction?
No but make sure your ar filter box is fully closed after replacing and make sure that ho2 sensor is working good
Where is inertia switch on 1988 Chevy C3500?
Chevy trucks did not have a inertia switch. You need to check the fuel pump fuse and relay and then make sure you have power back to the fuel pump that's in the fuel tank.
What is the ohm reading for the fuel rail sensor have?
The ohm reading for a fuel rail sensor typically ranges between 5 to 15 ohms, but this can vary depending on the specific vehicle make and model. It’s important to consult the vehicle’s service manual for the exact specifications. A significantly higher or lower reading may indicate a malfunction in the sensor. Always ensure the sensor is disconnected from the electrical system before taking resistance measurements.
If air in cooling system make gauge malfunction?
Yes, you need coolant around the sensor probe to have it function properly.
What can make a break in a circuit?
An on / off switch , fuel pump inertia switch , bad fuse etc
Where is the reset for the fuel pump on a 2003 jeep liberty?
How can you clean your fuel pump to make it work again
What does the code p1401 manufactured controlled auxiliary emissions control mean?
It depends on the make, but most likely a malfunction of the egr temperature sensor.
Where is the oxygen sensor in 1997 Olds Achieva and could a bad fuse make it malfunction?
No, a bad fuse will not cause a malfunction. O2 sensors are located on the exhaust system. there may be more than one. Any auto parts store can provide this info.
98 ford contour does crank sensor control spark and fuel?
yes but the cam sensor and the crank sensor work to geather so make sure to have it tested if you can to make sure wich is bad .
Will a bad map sensor make truck act like it starving for fuel?
It could
What is p1133 code?
AnswerA/F Sensor Circuit Response Malfunction!! Oxygen sensor bank one sensor one slow response or at limit. This code is for the front 02 sensor on the side of engine that has the number one cylinder. May be caused by vaccuum leak or bad sensor.
Where is the inertia fuel shut off switch?
Not enough info to answer. Please ask new question and include the year/make/model of the vehicle.
