An oil pressure switch works by detecting the pressure of the oil in the car and alerting you to any problems. Oil pressure naturally increases when a car is running, but if the pressure gets too high or drops, it can create numerous problems.
A pressure switch a valve that shuts off the unit when the pressure is to low or to high
it does not have a high pressure switch all it has is a evaporator temp sensor/switch.
You will definitely lose all of your Freon when you replace the high pressure switch. Once the high pressure switch is loosen the Freon will begin to access the system.
check to see if you have enough low side freon pressure and/or if the low pressure switch is working. bypass switch by crossing the wires of the switch with a paperclip to apply trigger voltage to the coil on the compressor,also check to see if there is voltage going to the low pressure switch,if these measures don't work,disconnect the high pressure switch to see if that switch is stuck and shutting off power thru the relay.
yes, if the fuel filter is clogged causing high back pressure on the fuel return it can pop off the injector fuel return lines [bypass hoses]
a hi pressure switch will limit the pressure by stoping motion (turn off motor) (unload cyclinder) ect
A pressure differential switch, is a switch that reacts to pressure difference of two points, usually your supply & return side. If the pressure between these points are high, it then "reacts" notifying of pressure problem on the system.
The AC high-pressure switch is typically a normally closed (NC) switch. This means that under normal operating conditions, the switch remains closed, allowing current to flow. If the pressure becomes too high, the switch opens, cutting off power to the compressor to prevent damage.
There is actually a low-pressure switch and a high-pressure switch. The low-pressure switch is located on the right side rear of the engine compartment on top of the AC accumulator. The high switch is on the AC high pressure line in the area behind the left headlamp assembly. Niether one is hard to replace, it's self-explanatory when you see them.
High pressure switch and or high temp switch. The high pressure switch is to tell the engine computer of the extra load to improve drivability. Not having one could lead to engine stalling in tight turns.
According to www.mayoclinic.com Gastric Bypass surgery is for people who have tried to lose weight but couldn't and suffer from health problems from weight. The criteria for people who need this surgery is being unable to maintain a healthy weight or diet, have a body mass index (BMI) of 40 or higher, and have serious health problems such as diabetes or high blood pressure.