I'm trying to figure out this site. Just found you. Questions about loosing 10095 excort loosing coolant.
Remove the bottom radiator hose on your 1996 Chevy Lumina radiator. Put a water hose in the top of the radiator. Allow the water hose to run until the water draining from the bottom of the radiator runs clear.
Remove the bottom radiator hose. Put a garden hose into the top of the radiator. Allow the garden hose to run until the water coming out of the bottom of the radiator is clear.
Remove the bottom radiator hose from your 1995 Chevy Lumina radiator. Put a water hose in the top of the radiator. Allow the water hose to run. Keep the water running until clear water runs out of the bottom of the radiator.
An easy way to flush a radiator is to remove the bottom hose from the radiator, and put a garden hose in the top fill hole, turn the water on, on the garden hose and let the water push the water out of the radiator. Do not start the truck. This is for flushing a radiator, not an engine. Dont forget to reattatch the bottom hose and refill the radiator as water will also flow out of the engine and will now be low.
In most cases the lower radiator hose feeds the water pump. The upper radiator hose feeds the radiator.
remove radiator hoses and run hose through upper hose hole, if theres any delay at all when water comes out lower hose hole then your radiator is clogged and blocking flow. any radiator shop will clean it for under $50.
you should find it attached to the radiator & the water pump. if it is missing, that's where you should put the new one. radiator at the front of the vehicle, engine behind it, water pump on front of engine, with hose, or short metal tube coming out of the bottom of it. the radiator will also have a hose or short metal tube coming out of the bottom of it also,(the radiator should also have another hose coming from it at the top)
1. Open the radiator cap. 2. Disconnect the top radiator hose. 3. Run the engine for a couple of minutes with the hose off. 4. Insert tap water hose into the radiator where the top hose should be. 5. Run water into the radiator until clear water comes out of the radiator top hose. 6. Continue idling the engine, remove the tap water hose from the radiator, shut off engine as soon as the water stops coming out of the top water hose of the radiator. 7. Reconnect top water hose and fill radiator with antifreeze. Start engine and top off antifreeze.
You might just need to replace the radiator hose or your radiator is cracked.
Drain the vans radiator. Remove the top radiator hose and water inlet. take the thermostat out. Put in the new thermostat and re install the inlet and hose. Refill the radiator.
Remove the bottom hose from your 1995 Chevy Corvette radiator. Allow the coolant to drain out. Put a hose into the top of the radiator. Run water through the radiator until it runs clear.
Remove the bottom radiator hose. Stick a hose in the top of the radiator. Turn the water on. Allow the water to run through the radiator and out the bottom of the radiator.