0
What else can I help you with?
Where do you put the water in a pt cruiser engine?
You add coolant to the reservoir and in the radiator cap.
Where do you put coolant in a 1997 BMW 328i?
In the coolant reservoir in front of the engine.
Where to put water and coolant Into a 2000 BMW X5?
The water and coolant is put in the coolant reservoir for the location of this refer to the owners manual. It is best to do this when the engine is cold otherwise you run the risk of getting boiling water all over you. the mixture of coolant to water should be about 50/50.
Where should you put antifreeze in a car?
In the coolant reservoir when the engine is cool.
What do you put in the coolant reservoir?
If the reservoir is low, ad a 50/50 mix of coolant and water. Or, buy it premixed and ad as is.
How do you put water in a Toyota rav4?
It is not suggested to put water in a Toyota Rav 4. The engine cooling system can get too hot and coolant is preferred. To pour coolant find the coolant reservoir and pour fluid until the max line is filled.
How do you put coolant in a 2001 Volkswagen Passat?
Fill the reservoir with G12 VW coolant only and it will go into the engine.
How do you put coolant back in the radiator in a 2001 Pontiac Grand Am GT since there is no cap on the radiator.?
Add the coolant into the coolant reservoir. Be sure the engine is cool when you remove the cap off the reservoir.
Can you put water only in the reservior for coolant?
It is possible to put water only in the reservoir for coolant on a car. However, this should only be a temporary fix until it can be repaired by a mechanic.
How do you put coolant in a 1994 Lexus sc400?
To add coolant to a 1994 Lexus SC400, first ensure the engine is cool. Open the hood and locate the coolant reservoir, which is typically near the radiator. Remove the cap and pour the appropriate coolant mixture (50% coolant and 50% distilled water) into the reservoir until it reaches the designated fill line. Replace the cap securely before starting the engine to allow the system to circulate the coolant.
Where to put coolant in a arctic cat ATV?
To add coolant to an Arctic Cat ATV, first locate the coolant reservoir, which is typically found near the engine or under the seat. Remove the cap from the reservoir and check the coolant level; if it's low, pour the appropriate coolant mixture (usually a 50/50 mix of antifreeze and distilled water) into the reservoir until it reaches the recommended level. Always ensure the engine is cool before adding coolant to avoid burns. Finally, securely replace the cap after filling.
Where do you put the coolant into a 1988 Volvo 240dl and what kind of coolant should you put in?
the coolant goes in the reservoir on the passenger fender. use a 50 percent water to 50 percent green coolant to fill it.
