answersLogoWhite

0

Yes but you have to be in level three orbit to do so

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How much to replace power steering pipes?

The cost to replace power steering pipes typically ranges from $150 to $500, depending on the make and model of the vehicle, labor rates in your area, and whether you're using OEM or aftermarket parts. Additional charges may apply if the power steering fluid needs to be replaced or if there are other related repairs. It's best to get a quote from a trusted mechanic for a more accurate estimate.


How do you take power steering cooling pipes off a peugeot 306?

To remove the power steering cooling pipes from a Peugeot 306, first ensure the vehicle is safely lifted and supported. Begin by draining the power steering fluid to avoid spills. Then, locate the cooling pipes, typically found near the front of the vehicle, and use appropriate wrenches to carefully disconnect the fittings. Finally, remove any mounting clips or brackets securing the pipes before pulling them out.


Where is the EGR valve in a 1982 Chrysler LeBaron?

near the power steering fluid holder.. its a round discy lookin thing with a couple of pipes attached to it..


Why does Power steering stop working sometimes?

PS usually stops working due to lack of PS fluid. This is more common in older cars because of it leaking out from older and deteriorated pipelines. Check for leaks and replace any pipes that appear to be cracked or leaking.


Where does power steering fluid go in an automatic?

This goes in the power steering pump under the bonnet you should see it located on the fan belt with 2 pipes going into it unscrew the cap and fill to level stated done.


How do you install a rack and pinion in a 2000 eclipse?

Elevate the car on a jack. Remove the nuts in the inner and outer tie rods. Loosen all nuts in the bulkhead hole cover. Take the lower joint offÊthe old rack and pinion. Detach the fluid pipes and mounting bolts. Remove the rack and pinion. Install the new ran and pinion and replace the mounting brackets. Connect the power steering fluid pipes. Align the lower shaft.


How do you replace a steering box on an E-150 1992 conversion van?

Being a conversion, you may have some interference from ground effect molding kits, sewage pipes, and the like. You should be prepared to deal with any such issues as they come up, or have an RV specialist deal with the job for you. That aside, we'll treat this as an unaltered ford van. First, you need to disconnect the two power steering fluid lines and allow the fluid to drain into a catch pan. You will the turn the steering wheel back and forth to force any significant amounts of fluid from the steering gear into the catch pan. Next, disconnect the steering gear from the steering shaf and also from the steering linkage. Then, remove the three bolts mounting the steering gear to the frame of the van. Install the replacement steering gear in reverse order of removing the old one. Next, fill the power steering fluid, and purge the system of air. You will now need to get the wheel alignment adjusted and then you're done.


How do you replace the slime pipes on bin weevils?

find the pipes and but them in the right places


How do you clear sediment from pipes?

You don't, you replace them.


Do you have to replace copper pipes?

Almost never.


How do you get limestone out of your pipes?

You don't. Treat water to help with water hardness. If pipes are clogged, replace them.


How can I replace the pipes under my bathroom sink?

To replace the pipes under your bathroom sink, first turn off the water supply. Use a wrench to disconnect the old pipes from the sink and the wall. Remove the old pipes and replace them with new ones. Reconnect the new pipes to the sink and the wall, ensuring they are securely tightened. Turn the water supply back on and check for any leaks.