Yes, you can use a lacquer thinner on carbon fiber. However, when doing so, make sure you water the thinner down first or add it to a solvent.
To a degree, but if you are concerned use lacquer thinner.
yes, mixture of 1/2 clear lacquer and 1/2 lacquer thinner. You can also use polyurethene spray
NO, all you will have is thinner, less effective paint. Primer has a totally different makeup.
Urethanes react with water and alcohols. To use lacquer thinner you need to be sure that it contains no IPO or IPA. Cheap lacquer thinners probably contain mainly toluol xylol and ketones; these should be OK. Just thin a little urethane lacquer and its hardener with the lacqer thinner and let it stand or apply to a small test patch. If it froths or goes funny in any way; forget it
It may or may not be effective. Traditional lacquer is a nitrocellulose-based coating. Thinners for nitrocellulose include acetone and ethanol (drinking alcohol). Most nail polishes are nitrocellulose lacquers, and that's why acetone is used as a nail polish remover.In general, the rule for thinners is that you need to use the thinner that was originally used to make the coating, or which is sold to be a thinner for the coating. If what's on your brushes isn't lacquer, lacquer thinner may not work as well as a thinner designed for the coating, and it may not work at all.If you already have lacquer thinner somewhere, or some nail polish remover, why not try a little bit to see if it works?
Well, honey, technically you can use lacquer thinner with red oxide primer, but I wouldn't recommend it unless you want a hot mess on your hands. Lacquer thinner is pretty strong stuff and might not play nice with the primer, so proceed with caution and maybe do a test patch first. Just remember, I warned ya!
Yes, lacquer thinner can be used as a degreaser. It is a strong solvent that can effectively remove grease, oil, and other substances from surfaces. However, it is important to use it in a well-ventilated area and follow safety precautions due to its strong chemical properties.
You can glue steel. De-grease it thoroughly first with gas or lacquer thinner, then use J B Weld.
Use Goof Off , or if needs to be stronger, acetone or lacquer thinner. ( They work on different materials.)
Use lacquer thinner on a rough rag. If necessary remove hardware from the door.
Possibly, if you really cleaned the tub aggressively with lacquer thinner or similar de-greaser.
If you are using polyurathane paint, using a general purpose lacquer thinner is not recommended, other than for cleaning equipment afterwards. For application, use only the correct thinners, of the same brand as the paint.