0
What else can I help you with?
How do you wire up an American legacy 1200 watt 2 channel amp to a 15 inch jackhammer?
To wire up an American Legacy 1200 watt 2-channel amp to a 15-inch Jackhammer subwoofer, first ensure you have the appropriate gauge speaker wire. Connect the positive terminal of the amp to the positive terminal of the subwoofer and the negative terminal of the amp to the negative terminal of the subwoofer. If the amp has two channels, you can either bridge the channels for more power or wire each channel to different voice coils if the subwoofer is dual voice coil. Finally, ensure all connections are secure and double-check the polarity before powering it on.
What is the appropriate wire size for a 125 amp circuit using THHN wire?
For a 125 amp circuit using THHN wire, the appropriate wire size would be 1/0 AWG.
How do you wire a dual voice coil to an amp?
If you want to run both coils,you have to wire the positive to positive and negative to negative on your sub,then run a wire from each plug to the amp. Positive to the positive side of the amp and negative to negative side of the amp,(you can run in bridge mode or stereo if your amp can handle the load)
What is the recommended wire size for a 100 amp circuit using THHN wire?
The recommended wire size for a 100 amp circuit using THHN wire is typically 3 AWG (American Wire Gauge).
What is the recommended wire size for a 200 amp service using aluminum wire?
The recommended wire size for a 200 amp service using aluminum wire is typically 2/0 AWG (American Wire Gauge).
Bridge two subs to a four channel amp?
If you amp is bridgeable you run + sub wire to ch 1 + then the -sub wire to the - of ch 2 of the amp. The same with the other sub + ch3 - ch4 that's how to bridge your amp.
How do you install two amplifiers into a subwoffer?
its better to get one amp for you sub then 2 because your going to have to spend more money with wiring and stuff. But if you really wanna do it you have to wire one voice coil to the other one and same for the other amp but if you have one voice coil you have to split the wiring into 2 neg and 2 pos then wire upto amp. HIGHLY NOT RECOMMENDED
What color wire is the remote wire when using an amp with a factory radio in a 2000 Monte Carlo?
Yellow Wire.
How would you hook up 2 8 ohm woofers with a 4 ohm dual voice coil woofer?
You could with a 4 channel amp. Bridge it to two channels and hook up the two 8 ohm woofers in parallel on the one bridged channel. Then hook the two coils on the dual coil woofer in series with the other bridged channel on the amp.
What does a inductive ammeter do?
It measures current by creating a coil around the current carrying wire. Current flowing in the wire induces a current in the amp-meter proportional to the current flowing in the wire.
How many channels do you need to power my subwoofer?
mono or two channel are the best for subs but it depends on if your sub is dual voice coil or single voice coil, what ohm load the amp can handle, and if it is single voice coil and are using one sub you need to make sure you can bridge a 2-channel amp if that's the kind you chose... Next question you ask it may help to add a bit more detail. If I knew the sub brand and model, ohms, and if it's dual or single voice coil i could help answer that much better.
How do you connect two amps to four subs?
Run a 2 sub per amp set-up. Get a distribution block for you power wire to split the power wire. You can run the remote wire from your stereo to one amp and then from the amp to the other amp. you will also need 2 sets of RCA's Easy way is too get a 4 channel amp to power 4 subs.
