0
Could a broken PVC elbow or vacuum line cause the crank position sensor to go out?
No it wouldn't, but jump starting the car or over heating the engine would crap out the sensor.
I'm in the process of changing my crank position sensor now, but my original broke in my engine block ... so I need to drill a hole so I can pull it out without pushing it in my block. :(
What else can I help you with?
What could cause no vacuum to the map sensor 2004 ford e350 6.0?
No vacuum to the MAP sensor on a 2004 Ford E350 6.0 could be caused by a vacuum leak in the intake manifold or associated hoses, which prevents the correct pressure from reaching the sensor. A clogged or faulty EGR valve could also restrict airflow, impacting the vacuum. Additionally, issues with the MAP sensor itself or its electrical connections might lead to a lack of signal or vacuum. Lastly, a malfunctioning engine or improper engine timing can contribute to inadequate vacuum levels.
What is wrong when the air conditioner on a 1989 Oldsmobile 98 regency blows out the top and not through the vents?
Could be a vacuum problem--either broken or disconnected hose or bad vacuum motor under dash or coming in through firewall Defrost is the default position for this system
What causes car to shake when engine idles below 1500rpm and is in park?
Have system scanned if check engine light is on. I would check for vacuum leak and if none were found do a tune-up if due. May need a fuel system check ,,,,fuel regulator, fuel injector, fuel filter. Could be throttle position sensor or crankshaft position sensor. Could be a computer problem.
Can you see a picture of crank position sensor?
no u could not
Your 1984 fiero 2.5 2m4 is idleing around 2700 RPMs need troubleshooting you already replaced the oxygen sensor but its still idleing high?
It could either be a leaking vacuum line, EGR Valve or I believe its a idle position sensor on the throttle body. If you're looking for a vacuum leak, spray some WD-40 around the vacuum lines till the engine RPM increases. You'll know right away. If it is a vacuum leak it could also be where the intake manifold joins the engine. In either case it is not a good idea to drive it as it could ruin your engine.
What is the problem with 1998 s10 not starting when it gets cold?
There are a few things that could be causing your S10 to not want to start in cold weather. You should check your throttle position sensor, coils or possibly a vacuum leak.
Why is your wrangler not sparking?
Possibly caused by a bad Crank Position Sensor. Could also be the cam position sensor or the coil. They all work together.
Where is the crank position sensor located on a 1993 Infinity G20?
trying to replace crank position sensor but i have no ideal where to look it is 1993 infinity G20 could you help me find this sensor
What does the code P1443 and or 420 mean on a 96 Ford Escort?
The p1443 code means a problem with the evaporative emissions system. There could be a problem with a broken or unhooked vacuum hose. Also could be a problem with the solenoid or sensor between throttle body and evaporative canister.
Where is Camshaft Position Sensor located?
The camshaft position sensor is most likely located on the cylinder head of the engine. The location could vary depending on the manufacturer.
2003 Ponitac Grand Am P1133 Manufactures COde?
You either have a bad oxygen sensor or a vacuum leak. Code P1133 indicates a faulty heated oxygen sensor but a vacuum leak could also cause this code.
Will a camshaft position sensor make your 2002 jeep hard to start?
It could.It could.
