Not always.....most of the time you need to take it to a certified garage or dealer. there they can flash the computer,which resets the light,unless the problem code continues to arise.
Disconnect the negative - terminal first, then the positive + terminal. Unfasten the battery hold down clamp. When reinstalling the terminal connections connect the positive terminal first.
One terminal is positive and the other terminal is negative. The positive terminal is slightly larger.
The positive + terminal is slightly larger.
Look for a + by the positive terminal and a - by the negative terminal, or red for positive, black for negative. Some batteries have the positive terminal protruding and the negative terminal flat. Or you can get a meter that will tell you which is which,
The longer leg of an LED is typically the positive (+) terminal, while the shorter leg is the negative (-) terminal. Additionally, the positive leg usually has a flat edge or a notch near it as a visual indicator.
Electrons have a negative charge. For that reason, electrons will always flow in the opposite direction of the current, which flows from positive to negative. Electrons will therefore move from a negative terminal to a positive terminal when we look at the load on a cell. Within the cell, the electrons will flow from the positive terminal to the negative terminal.
In a 2007 Boulevard S40 the positive terminal of a battery is located where the red terminal is. Another characteristic that separates it from the negative side is the width of the positive terminal.
It is called the positive + terminal or post, just like you list. Electrons flow for the negative - to the + terminal contrary to popular belief.Another AnswerAs electrons flow through the external circuit from anode (negative terminal) to the cathode (positive terminal) , then the answer is 'cathode'.
A positive terminal will usually have red surrounding, or over it.
Disconnect positive terminal on battery leave off for 1 minute then reconnect this should reboot your computer chip
The positive end of a battery goes to the positive end of the terminal. In retro spec, the negative end of a battery goes to the negative end of the terminal.
Corrosion or a very loose connection at the positive terminal.