drive it. It will reset itself
No. A 2006 Dodge does not have a reset.
No reset switches on a Dodge.
They are designed to not need a 'reset,' per se. All that is needed is to fill each tire to above 32 psi and the warning should go away. If it doesn't, then a sensor is faulty.
Reset a battery? There is no such thing as resetting a battery.
No, they're supposed to reset almost immediately after the pressure in the tire gets above about 32 psi.
no
your owners manual will tell you.
There is no reset. If replaced, it is calibrated with a scan tool.
To reset the tire pressure monitoring light on a 2010 Dodge Charger, first ensure that all tires are properly inflated to the recommended pressure. Then, turn the ignition to the "On" position without starting the engine. Press and hold the tire pressure monitoring system (TPMS) reset button, usually located beneath the steering wheel, until the light blinks three times, then release it. Finally, start the engine and drive for a few minutes to see if the light turns off.
The switch will automatically reset once all of the tires are above 32 psi (or whatever the sensor is set at). Check the decal on the driver door jamb for proper pressure settings.
Dodge does not use inertia/reset switches. The fuel system is computer controlled with relays.
The low pressure warning icon? That will automatically reset once the tire pressure is increased to above 32 psi. If the tire pressure is good on all tires, then the sensor itself is damaged. Did you just get new tires put on? Then the installer probably damaged the sensor.