Yes it does..the sensor is usually located on one of the drive shaft half shafts. It is located on the driver side. If you remove the wheel you migh be able to see it. I went under the car to replace. You might want to replace the speed sensor and odometer sensor while you are at it. Botha re in the same place but one is slightly higher. It took me about 1 1/2 hours to locate and replace, but once you know where they are it shouldn take more than an hour. Good luck with that.
code is P2008
There are two in the exhaust on each side of the engine.
there are 2 sensors. if your speedometer is inop replace the output speed sensor in trans drivers side. both look the same output is the one towards the rear.
Around 1 hour
A block heater was not standard equipment on a 2001 Chrysler 300m.
It is inside the tank, on the side of the fuel pump module.
Fluid, computer, sensor, wiring, internal failure.
the top speed on my 300m special is 149mph
Trouble code P0340 means:Camshaft position sensor circuit malfunction
yes
11
R134aR134a