0
What else can I help you with?
Cigarette lighter fuse in a Chevy pickup?
Where is the cigarette lighter fuse for a 2007 Chevy colorado
How do you install a generic cigarette lighter in a 1990 Toyota pickup that didn't come with one?
there should be a plastic trim piece that will pop out to the left of the ashtray any cigarette ligter should fit and then just hard wire to a fused circuit
What is the ignition timing for 1991 Toyota pickup?
wich engine do you have?
How doi remove ignition without key from 1986 Toyota pickup truck?
Begin by removing the retaining ring at the top of your 1986 Toyota pickup truck ignition switch. The ignition switch will slide out. Remove the wiring harness from the back of the ignition switch.
How can you hot wire the ignition on a 93 Toyota pickup?
I'm sorry, but I can't assist with that.
What is the ignition timing for 1984 Toyota Pickup?
Should be 8 to 10 degrees before TDC
Where is the cigarette lighter fuse in a 2007 Chevy Silverado Pickup?
In a 2007 Chevy Silverado Pickup, the cigarette lighter fuse is located in the fuse box under the dashboard on the driver's side. Specifically, you can find the fuse panel by opening the driver's door and looking for the fuse box cover near the left side of the dashboard. The cigarette lighter is typically fused with a 15-amp fuse, which can be identified in the fuse diagram located on the cover or in the owner's manual.
How do you remove ignition switch on 1989 Toyota pickup?
To remove the ignition switch on a 1989 Toyota pickup, first disconnect the battery to ensure safety. Then, remove the steering column cover by unscrewing the screws that hold it in place. Next, locate the ignition switch assembly, disconnect the wiring harness, and unscrew the switch from its mounting position. Finally, pull the ignition switch out and replace it if necessary.
Why does your 89 Toyota pickup not have spark at distributor?
Check the pickup inside the distributor and see if its OK. Do you have spark at the ignition coil? Check the wires. Or the cap and rotor assy.
How do you remove a cigarette lighter socket from a Chevy S10 pickup?
To remove the cigarette lighter socket from a Chevy S10 pickup, first, disconnect the battery to ensure safety. Then, use a flathead screwdriver to carefully pry off the decorative cover around the lighter socket. Once exposed, gently twist and pull the socket from its housing, disconnecting any wiring attached. Finally, if needed, unscrew any retaining screws before fully removing the socket.
Will a transmission from a 1993 Toyota pickup fit in a 1994 pickup?
A transmission from a 1993 Toyota pickup will fit into a 1994 Toyota pickup. The Toyota transmission will not fit in to other makes and models of pickups.
Replace cigarette lighter socket Chevy S10 pickup?
Gain access to the rear of the socket. Unplug the wires from the rear. Unscrew the housing and the socket will come out the front.
