0
What else can I help you with?
Does a manual transmission have a torque converter?
No, a manual transmission uses a clutch. Torque converters are used on automatic transmissions.
What is used to transfer energy through torque converter components?
ATF (Automatic Transmission Fluid)
What does a tcc solenoid do?
the TCC,, torque converter clutch,,,, used on tree speed transmission in the 80's GM and on 4 speed automatics, the solenoid reads the speed of the transmission (car) and sends the signal to the computer which identifies that the car has reached proper crusing speed and is not under heavey load (full throttle) it then "locK" the torque converter to not allow any slippage like a standard automatic torque converter, basically making the torque converter act like a clutch,,, thus the name TCC torque converter clutch hope that helps,,
How can you increase torque in transmission?
There is few ways of increasing torque inside the transmission. The most obvious one is using a torque converter of which is used to transfer rotating power from a prime mover such as the combustion chamber. Also, you can replace your rear end gears with taller gears.
What kind of transmission fluid is required for a 1990 Chrysler fifth avenue?
ATF+3 or ATF+4 should only be used to prevent transmission/torque converter shudder.
Why cant the torque converter bolts line up on a 1995 gmc 3500 with a 350 engine after switching with the same engine?
If the torque converter bolts on a 1995 GMC 3500 with a 350 engine aren't lining up after an engine swap, it could be due to misalignment of the torque converter or the flexplate. Ensure that the torque converter is fully seated in the transmission and that the flexplate is properly aligned. Additionally, check if the correct torque converter and flexplate combination is being used, as variations in part design may also affect alignment. Lastly, inspect for any obstructions or damaged components that may prevent proper installation.
What is a clutch on a automatic transmission?
since clutches are used in manual transmissions, automatic trans vehicles have whats called a torque converter and is a type of fluid coupling. its between the engine and trans allow the vehicle to come to a full stop without stalling the motor.
Is it compulory to have a fly wheel in a vehicle?
Yes, it is in a manual transmission vehicle since the flywheel is also used as part of the clutch as well as providing the necessary mass to reduce the effect of the torque pulses generated when each cylinder fires. In most cases in vehicles with automatic transmissions something called a torque converter serves a similar purpose. The torque converter is a somewhat doughnut shaped device which is filled with transmission fluid and weighs just about as much or more than than would a flywheel for this vehicle if it had a manual transmission.
What is transmission fluid used for?
Transmission fluid, like in automatic transmissions of cars, is used to transfer the power of the engine to the drive shaft. It's a hydraulic fluid, and the transmission is a hydraulic pump and a hydraulic drive all in one. The motor drives the pump (the torque converter), and it compresses the transmission fluid which in turn drives the clutch assembly.
How much horsepower does a stock 1990 Camaro RS V8 5.0L have?
Quote:AnswerIt also helps that the camaros with the 5.0 (I'm not sure if this applys to V6 or for standard transmissions) and an automatic transmission come STOCK with a torque converterThink about it, all automatics have to have a torque converter, otherwise there'd be nothing to put engine power into the gearboxon the other hand, standards would have a clutchsure there are semi automatics which have a manual shift and a torque converter, but this doesn't tend to be in quite the same way. and to my knowledge, no Camaro has ever used a system like this. mainly because it's a terrible way to do it, IMHONo, I mean that the automatics have a torque converter that kicks in at 2,200 rpm (if my memory serves me) which takes the extra torque and uses a separate set of gears to crank up the speed further, which is completely different from most automatic transmission. Because the 5.0 has so much torque compared to the horse power, the torque converter really makes a huge difference. The torque converter in the 3rd generation camaros is more like the kind you would put in a standard transmission for extra kick.yep, from that point of view, I can agree :)although I don't know the exact specs on the Camaro, never had anything to do with one
What is the Need for converter system used in power system?
to control a speed and torque.
What size bolt on a 700 R 4 transmission commonly used to bolt torque converter to flex plate?
Usually 3/8, but it's ok to step up to 7/16.
