No because Bondo is a brand not a product. If you are referring to plastic body filler, then the answer is also no. you must sand a refinish the area appropriately for a vehicle to look good.
Bondo Shoshitaishvili was born in 1939.
Bondo is very good for filling dents or holes. You must leave adequate time between fairly thin layers to get a good result. Don't try to fill deep dents in one go - it won't dry well.
Mixing bondo with water is not recommended, as bondo is meant to be mixed with a hardener to cure properly. Using water can compromise the strength and overall quality of the bondo. It is best to follow the manufacturer's instructions and mix bondo with the appropriate hardener for best results.
About 63km / 40 miles using Kisian - Bondo Road/Kisumu - Bondo Road/C27.
I was told that my uncle, Robert Spink, did........ he was known as "Bondo Bob"!!
Bondo is not a county but a constituency that is located in the county of Siaya.
the bondo was wiped to thick try laying a thinner layer
Let bondo air out, colder weather will make it take longer.
Bondo is not a county but is a constituency that is represented by Gideon Ochanda Ogolla.
The population of Roman Catholic Diocese of Bondo is 418,000.
Roman Catholic Diocese of Bondo was created in 1926.
Yes, you can put Bondo over fiberglass, but proper surface preparation is essential for good adhesion. The fiberglass surface should be clean, sanded, and free of any contaminants. Using a suitable primer can also enhance the bond between the fiberglass and Bondo. Always follow the manufacturer's instructions for best results.