No.
If the engine is not noisy then you have pressure. The cause is probably a failed oil pressure switch.
Dodge does not have a reset switch.
The oil switch on a 2001 Dodge Stratus 2.7L engine is towards the rear of the block on the right side of engine. The switch is covered by a triangular shaped heat shield that is secured by three bolts.
A Dodge Stratus does not have a reset switch.
There is none as your Dodge is not equipped with an inertia switch.
The low reverse pressure switch is part of the solenoid pack. That is the part on the front of the transmission case below the cooler hoses.
A Dodge Stratus does not have an inertia or reset switch. The fuel pump is computer controlled with relays.
No. A 1995 Dodge does not have a reset switch.
It is in the Solenoid pack, That is the plastic looking part on the front of the transmission case.
When working on a car engine, it is important to have an engine diagram. A Dodge Stratus engine diagram can be found in a Dodge forum online, or in the repair manuals at Auto shops.
The oil pressure sensor on a Dodge Caliber is under the intake manifold on the front of the engine.
Back side of engine, look for wire going to flat side of block backside. Reachable from underneath. Changed it while doing the oil. Fixed the light!