0
Does the battery need to be disconnected when replacing a fuel cut off switch on a 2003 Ford Explorer Sport?
I wouldn't think so , I saw a mechanic unplug the wiring harness to my fuel
pump shut off switch ( inertia switch ) with the engine running as a way of
removing the pressure from the fuel lines ( he just waited for the engine to stop
running after that )
So , just carefully unplug the wire connection to the switch
What else can I help you with?
Why would a 2005 Chevrolet Cobalt not start?
after replacing the stearing colum what would cause it not to start. You may have disconnected the ignition switch.
How do you reset the security after replacing ignition switch in a 2000 grand am?
unplug the battery for 2min
Why want my x Terra start after replacing the battery?
battery may not be the problem check your starter motor and ignition switch
How can I shut off the door ajar light and beep in a 06 Kia Sorento already disconnected the battery and it worked for a minute now its back on when i turn any degree to the right or go over a bump?
you may need to look into replacing the door jamb switch..
How long do it take to change the neutral safety switch in a 2010 Explorer?
Changing the neutral safety switch in a 2010 Ford Explorer typically takes about 1 to 2 hours, depending on your mechanical experience and the tools available. The process involves disconnecting the battery, removing any necessary components to access the switch, and then replacing it. It's important to ensure that the vehicle is safely secured and that you follow proper procedures to avoid any electrical issues.
Why wont the truck start even after replacing alternator and battery?
The solenoid (aka Starter Relay) on the Passenger Fender, could be defective. The ignition switch could be faulty. The Neutral Safety Switch (Automatic Transmissions) or the Clutch depressed switch are disconnected, or broken. On vehicles with EEC-IV there can be a problem with the PCM module, usually located under the glove box and behind the right kick panel.
Where is the back-up light switch for 1988 Volvo 240?
The back-up light switch for the 1988 Volvo 240 is located on the transmission. Specifically, it is mounted on the side of the transmission case, near the shift lever. To access it, you may need to raise the vehicle and remove any necessary undercarriage components for better visibility. When replacing or checking the switch, ensure the vehicle is safely supported and disconnected from the battery.
Where is the neutral safety switch located on a 1995 Ford Explorer and what is the procedure for replacing it please?
It is located on the drivers side of the transmission. You will have to remove the linkage to replace it. There should be directions with the new switch.
1994 Jeep Grand Cherokee Laredo wont turnover all power goes off when the switch is turned forward to start car?
Needs a battery, most likely. Have the alternator checked after replacing the battery. Additional Info: It could also be a loose battery connection - check the battery cable clamps. Also, if the battery needs to be replaced, lock and unlock your doors with the key as the alarm system activates itself when a battery is removed, disconnected or replaced. Cycling the door lock cylinders resets the alarm.
Why if you play music or not your battery always down even if im driving when you switch off the car its down?
Can be the battery is defective and needs replacing or the alternator is weak and needs replacing. Have your charging system checked. Most auto parts stores will do this for free.
Replacing the ignition switch on a 1993 ford Explorer?
Ford has an active recall on certain models of that era. It seems the ign switch has issues causing vehicle fires. check with several dealers to see which one is sincere about replacing it under the recall campaign good luck
How do you unplug a blower switch on a 97 Grand Prix so the car can be used until a new relay is installed?
If the relay is faulty, it just needs replacing to work. The switch would never need to be disconnected just to use the car.
