0
4 + 4 wired in paralell + to + and - to - will give you 2 ohms.
do this on both subs and then wire them together + to + and - to - and that will give you 1 ohm. so now get an amp that is 1 ohm stable 95% of mono block amps are. add your subs rms wattages together not peak let say your subs are 1200 peak and 600 rms then 600 + 600 equals 1200 watts rms is what you need.
so for this instance i would need a 1200 - 1500 watt rms mono block 1 ohm stable amplifier. I like more power just in case after the subs get broke in they want more power.
What else can I help you with?
What kind of amp should you hook up one lightning audio subwoofer 300 watts to?
Buy a cheap Jensen amp the 250watt 1.
What size of an amp should you get for a subwoofer in your 03 Jeep Liberty?
It depends on the power rating of the subwoofer.
When connecting a dual voice coil subwoofer to a mono amp what is the best way to connect the subwoofer to the amplifier?
To connect a dual voice coil subwoofer to a mono amplifier, the best method is to wire the voice coils in parallel if the amplifier supports the resulting impedance. This configuration will lower the overall impedance, allowing the amp to deliver more power to the subwoofer. If the amp cannot handle the lower impedance, you can wire the coils in series, which will increase the impedance but reduce the power output. Always check the specifications of both the subwoofer and amplifier to ensure compatibility.
What is a passive subwoofer?
A passive subwoofer doesn't have a built-in amp and will require the use of an amp.
Does subwoofer have fuse?
No the subwoofer itself does not contain a fuse. The Amplifier Connected to the sub should consist of a fuse or the power wire leading to the amp should contain one.
Why does your car stall after installing a subwoofer?
your car should not stall after installing a subwoofer. your problem might be the fact that your amp and your subwoofer(s) could be using too much of your cars electricity.
What should the low pass filter be set to?
If it is a subwoofer amp then set it at about 80 hz.
What amplifier power will I need to power dual 12" Rockford Fosgate subwoofers?
A Rockford 250 watt amp would compliment a 12" Subwoofer very nicely.
Is there an amp for the subwoofer in a 2001 Lincoln Navigator?
The amp is right next to the subwoofer. They are both located behind the rear driver side panel.
What is the largest pyle subwoofer?
You can get an 18" Pyle subwoofer but you will also need a large amp for it.
What amp do you use for a car subwoofer?
You must first check with the guide to your subwoofer. Either you can probably find it online , but you need to know the RMS wattage for the subwoofer. Than buy an amp that can put out the same number of watts and the RMS is for the subwoofer.
How do you wire up an American legacy 1200 watt 2 channel amp to a 15 inch jackhammer?
To wire up an American Legacy 1200 watt 2-channel amp to a 15-inch Jackhammer subwoofer, first ensure you have the appropriate gauge speaker wire. Connect the positive terminal of the amp to the positive terminal of the subwoofer and the negative terminal of the amp to the negative terminal of the subwoofer. If the amp has two channels, you can either bridge the channels for more power or wire each channel to different voice coils if the subwoofer is dual voice coil. Finally, ensure all connections are secure and double-check the polarity before powering it on.
